Votos - 4, Puntuación media: 3.5
(
)
)
|
Resumen del manual
Number of ......... Number of If you connect the to the car chassis (ground), turn may start a fire. Always 1 3 ......... 4 source running through the ......... 1 2CAUTION ......... 4 .........2 4 2 5 ......... 2 The use of any accessories except for those provided might damage to the unit. Make sure only to use the accessories shipped the unit, as shown above. Installation Procedure 1. To prevent a short circuit, remove the key from the ignition and disconnect the - battery. 2. Make the proper input and output wire connections for each unit. 3. Connect the speaker wires of the wiring harness. 4. Connect the wiring harness wires in the following order: ground, battery, ignition. 5. Connect the wiring harness connector to the unit. 6. Install the unit in your car. 7. Reconnect the - battery. 8. Press the reset button. • If your car's ignition does not have ignition wires to a power source that with the ignition key. If you connect the ignition wire to a source with a constant voltage supply, as with battery wires, the battery may die. • If the console has a lid, make sure to install faceplate will not hit the lid when closing and opening. • If the fuse blows, first make sure the wires aren’t touching to cause a short circuit, then replace the old fuse with same rating. • Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals. • Connect the speaker wires correctly to the terminals to which they correspond. The unit may be damaged or fail to work if you share the - wires or ground them to any metal part in the car. • When only two speakers are being connected to the system, connect the connectors either to both the front output terminals or to both the rear output terminals (do not mix front and rear). For example, if you connect the + connector of the left speaker to a front output terminal, do not connect the - connector to a rear output terminal • After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working properly. • Mount the unit so that the mounting angle is 30° or less. — 28 — Connecting ANT. CONT ILLUMI P.CONT FRONT • L FRONT • R REAR • L REAR • R – + FRONTFM/AM antenna input Rear left output (White) Rear right output Fuse (10A) Wiring harness (Accessory1) White/Black Gray/Black Green/Black Purple/Black White Gray Green Purple Ignition wire (Red) Battery wire (Yellow) 47 Ground wire (Black) - (To car chassis) Ignition key switch 41 Car fuse box (Main fuse) 42 ACC 44 Car fuse box 45 Battery If no connections are made, do not let the wire come out from 3 Front left output (White) Front right output (Red) Non-fading right output (Red) Power control wire (Blue/White) 16 Motor antenna control wire (Blue) 17 Dimmer control wire (Orange / White) (KDC-MPV7019/MPV619/X459/419 only) 19 4 When using the optional power amplif...
Otros modelos de este manual:Jugadores - KDC-MPV7019 (1.94 mb)
Jugadores - KDC-X459 (1.94 mb)
Unidad - KDC-319 (1.94 mb)
Unidad - KDC-4019 (1.94 mb)