Votos - 2, Puntuación media: 3
(
)
)
|
Fotos y especificaciones Pioneer DEH-50UB |
Otros manuales para este modelo:
Resumen del manual
The use of unauthorized parts may cause malfunctions. Consult with your dealer If Installation requires drilling of holes or other modifications of the vehicle. Do not Install this unit where: — It may Interfere with operation of the vehicle. — It may cause Injury to a passenger as a result of a sudden stop. The semiconductor laser will be damaged If It overheats. Install this unit away from hot places such as near the heater outlet. Optimum performance Is obtained when the unit Is Installed at an angle of less than 60°. Removing the Unit 1. Extend top and bottom of the trim ring outwards to remove the trim ring. When reattaching the trim ring, push the trim ring onto the unit until it clicks. (If the trim ring is attached upside down, the trim ring will not fit properly.) • It becomes easy to remove the trim ring If the front panel Is released. DIN Front/Rear-mount This unit can be properly Installed either from "Front" (conventional DIN Front-mount) or "Rear" (DIN Rear-mount Installation, utilizing threaded screw holes at the sides of unit chassis). For details, refer to the following Installation methods. DIN Front-mount Installation with the rubber bush 1. Insert the mounting sleeve into the dashboard. • When installing in a shallow space, use a supplied mounting sleeve. If there is enough space behind the unit, use factory supplied mounting sleeve. 2. Secure the mounting sleeve by using a screwdriver to bend the metal tabs (90°) into place. 2. Insert the supplied extraction keys into both sides of the unit until they click into place. 3. Install the unit as illustrated. Dashboard _ “lng sleeve 3. Pull the unit out of the dashboard. ( Installation English DIN Rear-mount 1. Extend top and bottom of the trim ring outwards to remove the trim ring. When reattaching the trim ring, push the trim ring onto the unit until it clicks. (If the trim ring is attached upside down, the trim ring will not fit properly.) • It becomes easy to remove the trim ting it the front panel Is released. 2. Determine the appropriate position where the holes on the bracket and the side of the unit match. 3. Tighten two screws on each side. • Use either truss screws (5 mm 8 mm) or flush surface screws (5 mm 9 mm), depending on the shape of screw holes In the bracket. Screw Fastening the front panel If you do not plan to detach the front panel, the front panel can be fastened with supplied screw. Screw Factory radio mounting bracket (Instalación Español □ Nota Verifique todas las conexiones y sistemas antes de la Instalación final. No utilice piezas no autorizadas. El uso de piezas no autorizadas puede causar un fallo de funcionamiento. Consulte su revendedor si se requiere taladrar agujeros o hacer otras modificaciones del vehículo para la Instalación. No Instale esta unidad donde: — pueda Interferir con la operación del vehículo. — pueda causar lesiones a un pasajero en el caso de una parada brusca. El láser semiconductor se dañará si se sobrecalienta. Instale esta unidad alejada de lugares callentes como cerca de la salida del calentador. Se obtiene el rendimiento óptimo cuando se Instala la unidad en un ángulo Inferior a 60,:'. Montaje delantero/trasero DIN Se puede Instalar esta unidad apropiadamente mediante el montaje "delantero" (montaje delantero DIN convencional) o montaje "trase...
Otros modelos de este manual:Unidad - DEH-4000UB (1.13 mb)
Unidad - DEH-5000UB (1.13 mb)