If the disc has a crack (especially around the center hole), it is recommended to make a copy immediately and use the copy instead. When a cracked disc is used continuously, the size of the crack is likely to grow and this will eventually result in irreparable damage to the disc. -- Important to read and understand at all times. SAMSUNG DIGIТай) everyone’s invite Avoid high-humidity environments. SAMSUNG DIGIТай) everyone’s invite Do not drop the drive, and protect it from severe shocks. - It can damage the drive or cause it to malfunction. > Do not move the drive while in operation and do not attempt to open the disc tray byforce. Make sure to close all working programs before attempting to open the tray and always use the open/close button. - Do not insert a pin into the emergency opening while in operation. > Do not use cracked, distorted or damaged discs. - In particular, a disc with a crack on the inner tracks may break while in use. SAMSUNG DIGIТай) everyone’s invite The 4-pin power cable from the internal power unit of your computer must be connected to the power terminal on the rear of the Optical drive. 1 +5V DC 2 Ground 3 Ground 4 +12V DC Note: An improperly connected power cable may cause trouble. Check the direction of the power connector and the incline side of the Optical drive before connecting. 2. Connecting the E-IDE cable Insert the IDE cable (40-pin), which is connected to the hard disk to the interface terminal. (Place the red line of the cable close to the Pin 1.) ^ When using one E-IDE cable Connect the cable to the SL (Slave) of the Master/Slave Select Terminal at the rear of the Optical drive. b a : Slave Drive (Choose the SL Jumper) b : Hard Drive c : MainBoard s When using two E-IDE cable * If there is only one Optical drive, select MA (Master). SAMSUNG DIGIТай) everyone’s invite Connect the 4-pin audio cable between the sound ou...
)
