Votos - 3, Puntuación media: 3.7
(
)
)
|
Resumen del manual
The watch’s auto light switch turns on illumination automatically when you angle the watch towards your face. • The auto light switch must be turned on (indicated by the auto light switch on indicator) for it to operate. • See “Illumination Precautions” for other important information about using illumination. To illuminate the display manually In any mode, press L to turn on illumination. • The above operation turns on illumination regardless of the current auto light switch setting. lllllllllll Auto light switch on indicator • You can use the procedure below to select either 1.5 seconds or 3 seconds as the illumination duration. When you press L, the illumination will remain on for about 1.5 seconds or 3 seconds, depending on the current illumination duration setting. To specify the illumination duration 1. In the Timekeeping Mode, hold down A until the display contents start to flash. This is the setting screen. 2. Press C 10 times until the current illumination duration setting ( or ) appears. 3. Press D to toggle the setting between (approximately 1.5 seconds) and (approximately 3 seconds). 4. Press A to exit the setting screen. llllllllllllll Operation Guide 3193 3200 5 About the Auto Light Switch Turning on the auto light switch causes illumination to turn on, whenever you position your wrist as described below in any mode. Note that this watch features a “Full Auto EL Light,” so the auto light switch operates only when available light is below a certain level. It does not turn on the backlight under bright light. Moving the watch to a position that is parallel to the ground and then tilting it towards you more than 40 degrees causes illumination to turn on. • Wear the watch on the outside of your wrist. Parallel to ground More than 40° Warning! • Always make sure you are in a safe place whenever you are reading the display of the watch using the auto light switch. Be especially careful when running or engaged in any other activity that can result in accident or injury. Also take care that sudden illumination by the auto light switch does not startle or distract others around you. • When you are wearing the watch, make sure that its auto light switch is turned off before riding a bicycle or operating a motorcycle or any other motor vehicle. Sudden and unintended operation of the auto light switch can create a distraction, which can result in a traffic accident and serious personal injury. To turn the auto light switch on and off In the Timekeeping Mode, hold down L for about three seconds to toggle the auto light switch on (auto light switch on indicator displayed) and off (auto light switch on indicator not displayed). • The auto light switch on indicator is on the display in all modes while the auto light switch is turned on. Power Supply This watch is equipped with a solar cell and a rechargeable battery that is charged by the electrical power produced by the solar cell. The illustration shown below shows how you should position the watch for charging. Example: Orient the watch so its face is pointing at a light source. • The illustration shows how to position a watch with a resin band. • Note that charging efficiency drops when any part of the solar cell is blocked by clothing, etc. • You should try to keep the watch outside of your sleeve as much as possible. Charging is reduced significantly if the face is covered only partially. Solar cell Important! • Storing the watch for long periods in an area where there is no light or wearing it in such a way that it is blocked from exposure to light can cause rechargeable battery power to run down. Be sure that the watch is exposed to bright light whenever possible. • This watch uses a rechargeable battery to store power produced by the solar cell, so regular battery replacement is not required. However, after very long use, the rechargeable battery may lose its ability to achieve a full charge. If you experience problems getting the rechargeable battery to charge fully, contact your dealer or CASIO distributor about having it replaced. • Never try to remove or replace the watch’s rechargeable battery yourself. Use of the wrong type of battery can damage the watch. • All data stored in memory is deleted, and the current time and all other settings return to their initial factory defaults whenever battery power drops to Level 5 and when you have the battery replaced. • Turn on the watch’s Power Saving function and keep it in an area normally exposed to bright light when storing it for long periods. This helps to keep the rechargeable battery from going dead. Level 1 2 3 4 5 Battery Power Indicator (Charge Soon Alert) Function Status All functions enabled. All functions enabled. Auto and manual receive, illumination, and beeper disabled. Except for timekeeping and the CHG (charge) indicator, all functions and display indicators disabled. All functions disabled. l l l l l l l lll l l l l l l l l l lll l l Battery Power Indicator and Recover Indicator The b...
Otros modelos de este manual:Relojes - 3193 (1.1 mb)