Votos - 2, Puntuación media: 3.5
(
)
)
|
Resumen del manual
• Rechargeable batteries are to be removed from the product before they are charged. • If you use a battery charger, it should be examined regularly for damage to the cord, plug, enclosure and other parts. Do not use a damaged battery charger until it has been properly repaired. Hint: We recommend using alkaline batteries for longer battery life. Hint: If the swinging motion becomes noticeably slower, remove the batteries and replace them with three, new “D” (LR20) alkaline batteries. Dispose of exhausted batteries properly. • Using a coin, press the tab on the battery compartment door and remove it. • Insert three “D” (LR20) alkaline batteries, as indicated inside the battery compartment. • Replace the battery compartment door. Cradle and Swing Use Cradle and Swing Use Your Cradle Swing changes from a traditional swing to a rocking cradle at the push of a button! IMPORTANT! Before each use or assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Fisher-Price® for replacement parts and instructions if needed. Never substitute parts. Cradle Side-to-side swinging motion soothes baby. Swing To Unfold Leg 1 Leg ButtonButton • Firmly pull the legs outward. Make sure the buttons snap into the notches in the motorized frame. • Check to be sure the legs are locked into position by pushing the legs inward. The legs should not move. To prevent injury or death from falls or sliding out, always use the restraint system. Never rely on the tray to restrain child. WARNING Head-to-toe swinging motion entertains baby. 8 Cradle and Swing Use 9 Restraint Belts • Place your child in the seat. • Pull the crotch belt up between your child’s legs and fasten both waist belts to the crotch belt.Make sure you hear a “click” on both sides. To tighten the waist belts: • Feed the anchored end of the waist belt up through the buckle to form a loop . • Pull the free end of the waist belt . • Repeat this procedure to tighten the other waist belt. To loosen the waist belts: • Feed the free end of the waist belt up through the buckle to form a loop . • Enlarge the loop by pulling on the end of the loop toward the buckle. • Pull the anchored end of the waist belt to shorten the free end of the waist belt . • Repeat this procedure to loosen the other waist belt. B A B A 2 4 5 Waist Belt Waist Belt Crotch Belt Power Settings Power Dial To start: • Turn the power dial to the medium setting.The power indicator lights. • Give the seat a light push to start the swinging motion. Adjust the power dial to the desired swing motion setting: low, medium or high. • Fit the tabs on the tray into the slots in the sides of the seat. • To remove the tray, pull the tab out on one side of tray and lift. Tab Slot Using the Tray Anchored End Free End B A To Tighten Buckle Anchored End Free End A B To Loosen 3 Hints: - As with most battery-powered swings, a heavier child will reduce the amount of swinging motion on all settings. In most cases, the low setting works best for a smaller child while the high setting works best for a larger child. - If the low setting provides too much swinging motion for your child, try placing one end of a blanket underneath your child and let the other end of the blanket drape down while swinging. Cradle Swing Swing Cradle and Swing Use 10 Adjust Positions You can adjust the seat tube to three different positions: • Press the seat tube button to unlock the seat tube. • Rotate the seat tube to the desired position. Adjust to Recline or Upright Positions You can adjust the seat to two different positions: Recline or Upright. • From behind the seat, press both seat position buttons. • Push the seatback up until the buttons “snap” into the upright position. • Push the seatback down until the buttons “snap” into the recline position. 6 8 Seat Tube Button Seat Tube Front Edge of Seat Press Seat Position Buttons Upright Recline • Press the buttons on the back of the motorized frame while pushing the legs inward. Button Button Storage 7 9 • Lean the Cradle Swing frame against a wall for storage. IMPORTANT! Remove the batteries for long-term storage. Hint: The legs may be disassembled for long-term storage. Simply press the buttons on the legs and remove the upper and lower legs. Power indicator does not Power is not on Turn the power dial to low, medium or high. light, motor is not running Batteries incorrectly installed Remove the batteries and replace in correct orientation, as illustrated in the battery compartment. Dead batteries Replace all three batteries with three, fresh “D” alkaline batteries. Motor is running but Need to start swinging motion To start swinging motion, give the seat a light push. swinging stops after a few minutes Swing motion setting is Adjust the power dial to another setting and give inappropriate for child’s weight the seat a light push. Weak batteries Replace all three batteries with three, fresh “D” alkaline bat...
Otros modelos de este manual:Accesorios de Bebes - 79596 (1.55 mb)