Votos - 0, Puntuación media: 0
(
)
)
|
Resumen del manual
m HOLD is slid in the direction of the arrow. Slide HOLD in the opposite direction of the arrow. No sound comes from the speaker. m The earphones are plugged in to EAR/MIC. Disconnect it. m The volume is turned down completely. The sound drops out, sound quality becomes worse or sound has excessive noise. m The volume is turned down completely. m The batteries are weak. Replace the battery for the main unit and both batteries for the speaker unit, if the speaker is installed, with new ones. m The record/playback head is contaminated. m The earphone plug/microphone plug is dirty. Clean the plug, insert it into the jack, turn it few times, then disconnect it and connect it again. m If the cassette has been put on a speaker without its case, the sound quality may be distorted. Recording is interrupted. m The VOR system is working. When you do not use VOR, press it to make VOR L or VOR H disappear from the display window. Recording cannot be erased completely. m The erase head is contaminated. z Additional Information Precautions On power Operate the unit only on 1.5V DC. For AC operation, use the AC power adaptor recommended for the unit. Do not use any other type. For battery operation, use two size AAA (R03) batteries. On the unit • Use only the y (standard microcassettes) with this unit. Non-standard cassettes cannot be used because their “L” dimension (see illustration) is different. • Do not leave the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. • Should any solid object or liquid fall into the unit, remove the batteries or disconnect the AC power adaptor, and have the unit checked by qualified personnel before operating it any further. • When you do not use the unit for long, remove the batteries to avoid damage caused by battery leakage and subsequent corrosion. • If the unit has not been used for a long time, set it in the playback mode and warm it up for a few minutes before inserting a tape. Keep personal credit cards using magnetic coding or spring-wound watches etc. away from the unit to prevent possible damage from the magnet used for the speaker. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. Using Various Functions To select the side to be recorded To record on both sides continuously 1 Insert a cassette with the side to start recording facing the lid. 2 Start recording on the upper side (9 FWD appears in the display window). If REV ( is displayed, press p STOP for more than 2 seconds to display 9 FWD. When recording reaches the end of the upper side, it will automatically continue on the reverse side. Notes • Make sure the tabs on both sides are not removed. • Even if only the tab on the reverse side is removed, recording cannot be made. To Record on one side only 1 Insert a cassette with the side to start recording facing away from the lid (reverse side). 2 Start recording on the reverse side (REV ( appea...