Votos - 0, Puntuación media: 5 ( )

Fabricar: Grizzly Tamaño del archivo: 197.18 kb Nombre del archivo: Idioma del manual:

NOTE: It may be necessary to cut or grind the end of the bit that fits into the chuck so there will be proper clearance below the edge of the chisel. Secure the bit in the drill chuck. 4. Fasten the fence assembly to the table. Ensure that the fence is positioned so it is square to the side of the chisel and set at the desired distance from the back of the chisel. Mortising 1. Mark your mortise on the workpiece. Without drilling any stock, check the chisel position against the layout line. Make adjustments as required. 2. Remove the workpiece from under the mortising chisel and adjust the spindle stop to the desired depth. Crank the spindle down to make sure everything is clear. 3. Position the hook clamps against the side o the workpiece. 4. Adjust he hold-down so it is just above the workpiece and secure into position with the lock knob. 5. For best results, select a drill press speed of 650 to 1000 RPM. 6. Cut mortises in sequence as shown above. The distance between position 1 and 2, 2 and 4 and so on should be less than the width of the mortising chisel. Sharpening The mortising bit and chisel must be periodically re-sharpened. Sharpen mortising chisels with a round slipstone, working from the inside of the chisel to the edge. Do not sharpen the outside edge. Any burr on the outside edge of the chisel caused by sharpening the inside must be removed with a flat stone. Sharpen the mortising bit with a flat stone or triangular file. COPYRIGHT © 1999 BY GRIZZLY INDUSTRIAL, INC. REVISED OCTOBER, 2007 (TR) WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC. #BA0520 PRINTED IN TAIWAN W1 Wi 13-1 13-2 13-3 13-4 13-5 MORTISING ATTACHMENTS NOT SUPPLIED WITH CHISELS. REF PART # 13 DESCRIPTION 1 P1083001 CONE 2-19/32 - 66MM 1 P1370001 CONE 2-3/8'' 1 P1514001 CONE 1-5/8'' 1 P1515001 CONE 1-7/8'' 2 PB23 HEX BOLT 5/16-18 X 2-1/2 3 PN02 HEX NUT 5/16-18 4 P1083004 KNOB 5 P1083005 HOLD DOWN CASTING 6 PB30 HEX BOLT 5/16-18 X 4-1/2 7 PW07 FLAT WASHER 5/16 8 P1083008 ROD 9 P1083009 BRACKET 10 P1083010 HOLD DOWN ROD 11 P1083011 FENCE 12 PWN03 WING NUT 5/16-18 13 P1083013 SET OF 5 CHISELS 13-1 P1083013-1 MORTISING CHISEL - 1/4" 13-2 P1083013-2 MORTISING CHISEL - 5/16" 13-3 P1083013-3 MORTISING CHISEL - 3/8" 13-4 P1083013-4 MORTISING CHISEL - 1/2" 13-5 P1083013-5 MORTISING CHISEL - 5/8" 10...

Descargar ahora

Introduzca dos números de la imagen: