Votos - 5, Puntuación media: 4.6
(
)
)
|
Resumen del manual
24. AUDIO button Press to access various audio languages or tracks, when the DVD disc contains multiple audio languages or tracks System Connections Note: Before plugging the power cord into an AC outlet, make sure that all other connections have been made as described below. Power Supply Connection Connect the supplied adapter to the side of the DVD player in the jack marked “DC 12V IN”. Plug the two-prong end of the power cord to an AC100-240V outlet. If you have difficulty inserting the plug, turn it over and reinsert it. If the DVD Player will not be used for a long time, disconnect the plug from the outlet. Connecting to a TV Audio/video connections Always ensure that the DVD player, TV and any other electrical components are switched OFF before connecting to the DVD player. The easiest way to connect the DVD player to a television is via the supplied Audio/Video cable. Connect the audio/video cable from the DVD player to the audio/video inputs of the TV. And then switch the AV IN/OUT button to OUT. Note: Noise may occur in speaker when there is an external audio signal input while playing a DVD disc. Unplug the audio cord to clear the noise. This player only outputs NTSC signals. Make sure to use NTSC input type monitor/TV. If the picture is distorted or colorless, please check the type monitor/TV. Do not connect an audio/video input while the A/V in/out switch is in the out position. This may result in unwanted audio or video distortion. - 11 - System Connections Connecting to an Amplifier The DVD player can be connected to an amplifier. Plug the supplied A/V cable into the audio jack on the right side of the unit and plug the other end into an audio input on the amplifier (White= left, Red=Right). Please refer to the equipment’s manual before connecting. - 12 - System Preparations Using of Remote Control 1. Remove the battery holder. Refer to the figure above. 2. Insert the battery into the battery holder (observe correct polarity) and insert the battery holder into the remote. 3. For best results, aim the remote directly at the player’s IR receiver window, within 15 feet, and angles not exceeding 60 degrees. The path between the remote control and remote sensor should be free of obstructions. 4. Under normal use the battery will last for approximately one year. 5. Remove the battery if the remote is not to be used for a long time. 6. Battery type is a CR2025 - 13 - System Preparations Disc Formats Supported By This Player DISC LOGO DIAMETER PLAYBACK TIME/ PLAYABLE SIDES DVD DVD-R 12cm 133 min (SS-SL) 24 2 m i n ( S S -DL ) 26 6 m i n ( D S -S L ) 484 min (DS-DL) 41 min (SS-SL) 8cm 75 min (SS-DL) 82 min (DS-SL) 150 min (DS-DL) CD CD-R CD-RW 12cm 74 min 8cm 20 min The disc maker specifies the operation of some DVD discs. Please refer to the instruction manual with the disc. Care of Discs Cleaning of Discs Do not touch the playing surface of the If a disc has fingerprints or dust on it, disc. lightly wipe the disc with soft cloth from Do not stick paper or labels on the disc. the center of the disc outward. Storage of Discs Never use record cleaning sprays, or Do not expose discs to direct sunlight or any other solvents to clean your discs. excessive temperatures. - 14 - Power Supply Rechargeable Battery Pack Your portable DVD player comes with a lithium ion rechargeable battery that attaches to the rear of the DVD player. Charge the battery fully before initial use. Charging time is normally about 5 hours. A fully charged battery delivers about 2-1/2 to 3 hours of use, but playing time varies from disc to disc. If the battery will not be used for a long period of time, fully charge the battery prior to storage. Working conditions and precautions of the battery • New batteries must be fully charged before initial use. Regardless of the charge indicator, allow the battery to charge for 8 hours. • Battery should only be used and charged when temperatures are between 32 100F. • Never put the battery in fire or water. • Do not expose the battery to high temperatures or store in hot, sunny places. • Maintain well-ventilated conditions around the product to avoid overheating. Don’t put the product on bed, sofa or anything that may block ventilation to the product. • Do not short the battery terminals. • Do not open the battery. • Detach the battery after charging is complete. When charging the battery pack, the charge light will turn red, when the charging is complete, the light will turn OFF. • Detach the battery when not in use. • When the battery is weak, “Low Power” will appear on the LCD screen and about one minute later, the player will power OFF automatically. - 15 - Power Supply Attaching the Battery Pack Refer to the following steps for attaching the Battery Pack: 1. Place the DVD Player on a soft and smooth surface with the bottom of the unit facing UP (chassis up see the Fig.1). 2. With one hand on the DVD Player to prevent it from moving, take the battery and align the four (4) plastic tabs on t...