Votos - 3, Puntuación media: 4
(
)
)
|
Resumen del manual
When you open the door again, you will find two marks on the jam side where the contacts met it. 2. Using these marks as a guide, centerthe striker plate template between the two marks and center punch a mark where the two male terminals will pass through, also center punch the two mounting holes. NOTE: Minimum 1/2" hole must be drilled forthe terminals to pass through to insure clearance forthe terminals and to prevent shorts. 3. Drill the 1/2" hole forthe terminal pass through, also drill the two 1/8" mounting screw holes. 4. Pass the two (Blue and Green) wires from the PDL-4 control module through the striker gasket and attach them to the terminals of the striker plate. 5. Mount the striker plate and gasket to the doorjam using the two screws provided. Again lubricate the switch contacts, close the door, and confirm that the contacts meet the striker plate. Check for proper operation of the actuator by operating the door locks from either door lock switch. Power Door Lock Actuator Spring Leaded Contact s ^ I—«=□ E=C GREEN WIRE L-cO e=£ Striker Plate y y...
Otros modelos de este manual:Puertas y ventanas - PRO-PDLVS (85.66 kb)