Votos - , Puntuación media: ( )

Manual de usuario Lennox Hearth, modelo Decorative Style View SDDV-35

Fabricar: Lennox Hearth
Tamaño del archivo: 447.51 kb
Nombre del archivo:

Idioma del manual:

El documento se está cargando, por favor, espere

Descargar ahoraCerca

El documento se está cargando, por favor, espere

Descargar ahoraCerca

If you encounter any problems, need clarifi cation of these instructions or are not qualifi ed to properly install this kit, contact you local distributor or dealer. 3 4 Figure 1 WARNINGS Hot! Do not touch! These decorative screen doors are NOT heat guards. The ceramic glass behind the screens will be hot during operation and will retain heat for a while after shutting off the appliance. Severe burns may result. Carefully supervise children in the same room as appliance. • As with any similar heating appliance, surfaces of the frame and doors including handles can become very hot. Avoid touching the glass or screen door surfaces when operating the doors. • Use care when opening doors . Avoid exerting any downward pressure on the doors when they are in an open position. Excessive force can cause the doors to come loose or be damaged. • The lower screen panel covering the controls will become hot during operation. Use care when removing the panel to access the controls and make sure to place the screen on a surface that is non-combustible or will not be damaged by high temperatures. • INSTALL ONLY WHEN THE FIREPLACE IS OFF AND COLD! Kit Contents (see Table 2) Read and understand all instructions and warnings in this document before beginning the installation. INSTALLATION INSTRUCTIONS FOR DECORATIVE ARCH SCREEN PANEL KIT FOR USE WITH LMDV-35/40/45, MPD-35/40/45, MPD35ST, EDV-35/40/45, EDVST & EBVST GAS FIREPLACES 1 2 6 4 5 INSTALLATION INSTRUCTIONS: 1. Remove Top and Bottom Panels a. Remove the top louvered or radiant panel/hood assembly by pulling the assembly up and out (see Figure 2). In instances where the radiant panel is used and it is framed in with tile or other approved material, the hood must still be removed by firmly pulling it forward until it releases from the receiving brackets. b. Remove the bottom louvered or radiant panel/hood assembly (refer to Homeowner’s Care and Operation Manual). Figure 2 -Remove Top Panel Remove Trim Panels as shown. The trim panels will be either Louvered Panels or Radiant Panels. Louvered Panels Radiant Panels c. Remove Bustles -Some models have bustles (as shown in Figure 3) which must be removed. If applicable, remove the top and bottom bustle by lifting them up and out. Bustles Figure 3 - Remove Bustles Lift Bustles Up And Off Only Some Models Have Bustles 2. Align Glass Door (see Figure 4) -Ensure the glass door assembly on the fi replace is properly aligned as follows: Note: Units with Modesty Panels - Remove the modesty panel, if necessary, as follows: Lift the modesty panel by the tab on the panel’s right end, pull the right end of the panel away from cabinet and then pull the panel diagonally out of the corner post slots on the left side of the unit. Remove the modesty panel carefully, so that none of the wires become loose or disconnected. a. Open the latch(es) at the bottom of the glass door assembly as shown in Figure 4 (refer to Homeowners Manual). b. Adjust glass door so that it is evenly spac...