Votos - 3, Puntuación media: 4
(
)
)
|
Resumen del manual
is flashing or the vehicle will not start. REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - SUCCESSFUL START: 1) Press remote start button or for RS901 model activate Green Start input wire. 2) Parking lights flash once, then turn on solid, Ignition/Acc On. 3) After 6 seconds Starter Motor engages, Parking lights and Acc circuits turn off while cranking. 4) Engine Starts and Runs. Parking Lights and Acc turn back on, Doors Lock. 5) Engine will remain running for programmed run time until reset with Brake pedal. If needed, the engine can be turned off with remote transmitter or for RS901 model, activating the Green Start input wire. AFTER IGN 6 STARTER THEN START FLASH 1X SOLID SOLID SEC. REMOTE ENGINE CONTROL REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - UNSUCCESSFUL START In the event that the engine does not start on the first attempt, the system shuts down for a few seconds, then attempts to restart the engine a 2nd and 3rd time. For hard starting engines, the unit will allow a starter crank time of up to13 seconds maximum. This should provide ample cranking time for difficult starts, but is limited to 13 seconds to help prevent damage to the starter from over cranking in the case of a malfunctioning unit. 1) If engine starts on 2nd or 3rd attempt, see steps 4 & 5 above of "Successful Start". 2) If Third attempt fails to start engine, the system will turn off and doors will remain locked. NO FURTHER ATTEMPTS WILL BE MADE AUTOMATICALLY TURNING OFF A REMOTE STARTED ENGINE: 1) Engine is running in Remote Start (Parking lights ON). 2) Press Remote Start button or for RS901 model activate Green Start input wire. 3) Engine turns & parking lights OFF, Doors remain locked or will re-lock/re-arm if applicable. START IDLE DOWN MODE: This mode allows the unit to take over operation of the parked vehicle while the ignition key is removed and you exit the vehicle. The vehicle is put into a remote running condition before you exit and it will remain running for the programmed run time or until you come back. Examples: • You pull up to a convenience store for a quick stop, "Idle Down" mode keeps engine running when you exit the vehicle, (with keys in hand) remote lock doors or arm alarm. When you return, unlock or disarm alarm, turn ignition ON and drive away. • On some Turbocharged vehicles it is recommended that the driver leave the car at idle for a short time before turning the car off to allow the turbo to cool down. REMOTE ENGINE CONTROL REMOTE ENGINE CONTROL IDLE DOWN MODE - EXITING THE VEHICLE: 1) With engine running, press Remote Start button or for RS901 model activate Green remote start input wire. 2) Parking Lights will turn ON. 3) Doors will unlock, or if brake pedal is being depressed doors will unlock when it is released. 4) Turn OFF Ignition and remove key. Engine should remain running. 5) Exit vehicle then remote lock doors if desired. 6) Engine will remain running for programmed run time or until you return (whichever comes first). IGN SOLID OFF START UNLOCK ENTERING A VEHICLE DURING “IDLE-DOWN” or “INFINITY RUN” MODES: 1) With engine running in "IDLE DOWN" (parking lights ON), unlock door or (Remote unlock or disarm alarm if applicable) 2) Enter vehicle and be careful not to step on brake pedal! (Remote Start Reset) 3) Turn Ignition to ON/RUN position, then depress brake pedal to reset the Remote Starter. Parking lights will turn off. Then drive away. FLASH 2X START IGN OFF SOLID UNLOCK REMOTE ENGINE CONTROL REMOTE ENGINE CONTROL INFINITY RUN MODE (RS900 ER III ONLY) This mode can only be engaged when "Idle Down" is being engaged. It allows the vehicle engine to remain running INDEFINITELY after the programmed run time elapses. This mode will allow the vehicle to be left running and unattended without the ignition key in the switch preventing the vehicle from being stolen. This mode can be beneficial to law enforcement, commercial, or work trucks that need to remain running unattended for long periods of time. INFINITY RUN MODE – EXITING THE VEHICLE: (NOT AVAILABLE ON RS901) 1) Have engine running with the Key, then press the Start button on the transmitter once, pause a few seconds, then press the remote start button a second time. 2) Parking Lights will start flashing, and doors will unlock. 3) Turn Ignition switch OFF, remove key and exit the vehicle. Engine should remain running. 4) The vehicle’s parking lights will flash for the programmed run time of 12, 24, or 36, or 48 minutes and then switch to solid while motor runs indefinitely or until fuel supply runs out. IGN OFFSTART FLASH FOR PROGRAMMED 2X RUN TIME, THEN SOLID TIMED SELF START MODE This mode allows the vehicle to be programmed to self-start every 4 hours and run for the programmed run time. This can be helpful during extremely cold conditions where engine fluid freeze-up is a concern. Be sure that the vehicle is outdoors or in a well ventilated area. Once the timed self-start mode is set, the unit will start every 4 hours and run for t...
Otros modelos de este manual:Puertas y ventanas - COOLSTART RS900ER (103.55 kb)