Votos - 3, Puntuación media: 4
(
)
)
|
Otros manuales para este modelo:
Resumen del manual
• You can resize the images later ([Resize], page 20). • When an image was recorded using an earlier Sony model and is played back on the camera, the image may not appear in the actual image size. [ The approximate recording time of movies The numbers in the table below show the approximate maximum recordable time obtained by totaling all movie files. The maximum length of time you can shoot continuously is about 10 minutes. (Units: hour : minute : second) Capacity Internal memory “Memory Stick Duo” formatted with this camera Size Approx. 22MB 128MB 256MB 512MB 1GB 2GB 4GB 8GB 320.240 0:01:00 0:05:50 0:10:40 0:22:00 0:45:00 1:30:50 2:59:50 6:01:10 • The aspect ratio of the movie frame is 320.240. Troubleshooting If you experience trouble with your camera, try the following solutions. 1 Check the items below, and refer to “Cyber-shot Handbook” (PDF). 2 Remove the batteries, wait for about one minute, re-insert the batteries, then turn on the power. 3 Initialize the settings (page 21). 4 Consult your Sony dealer or local authorized Sony service facility. Be aware that by sending the camera for repair, you give consent that the contents of the internal memory may be checked. Batteries and power The battery remaining indicator is incorrect, or sufficient battery remaining indicator is displayed but the power runs out too quickly. • This phenomenon occurs when you use the camera in an extremely hot or cold location. • When using alkaline batteries/Oxy Nickel Primary Battery (not supplied), the displayed time remaining may not be correctly indicated. • The batteries are discharged. Insert new batteries or charged Nickel-Metal Hydride batteries (not supplied) (page 9). • When using the Nickel-Metal Hydride batteries, the poles of batteries or the terminals of the battery cover are dirty so the batteries are not charged sufficiently. Clean them with a cotton swab, etc. • When using the Nickel-Metal Hydride batteries, the displayed time remaining differs from the current one due to the memory effect, etc. Fully discharge and then charge the batteries to correct the display. • The batteries are dead. Replace them with new ones. The batteries run down too quickly. • You are using the camera in an extremely cold location. • The batteries are dead. Replace them with new ones. • When using the Nickel-Metal Hydride batteries, charge them sufficiently. Camera power is turned off automatically when you open the battery/“Memory Stick Duo” cover. • This is not a malfunction. Turn off the camera before you open the battery/“Memory Stick Duo” cover. Cannot turn on the camera. • Insert the batteries correctly (page 9). • Properly connect the AC Adaptor (not supplied). • The batteries are discharged. Insert new batteries or charged Nickel-Metal Hydride batteries (page 9). • The batteries are dead. Replace them with new ones. The power turns off suddenly. • If you do not operate the camera for about three minutes while the power is on, the camera turns off automatically to prevent wearing down the batteries. Turn on the camera again (page 11). • The batteries are discharged. Insert new batteries or charged Nickel-Metal Hydride batteries (page 9). Shooting still images/movies Cannot record images. • Check the free capacity of the internal memory or “Memory Stick Duo” (pages 25, 26). If it is full, do one of the following: – Delete unnecessary images (page 15). – Change the “Memory Stick Duo”. • You cannot record images while charging the flash. • When shooting a still image, set the mode dial to a position other than . • Set the mode dial to when shooting movies. Cannot insert dates on images. • The camera does not have a feature for superimposing dates on images. By using “Picture Motion Browser”, you can print or save images with the date. Vertical streaks appear when you are shooting a very bright subject. • The smear phenomenon is occurring and white, black, red, purple, or other streaks appear on the image. This phenomenon is not a malfunction. Viewing images Cannot play back images. • Press (Playback) (page 15). • The folder/file name has been changed on your computer. • Sony does not guarantee playback of image files on the camera if the files have been processed using a computer or recorded with another camera. • The camera is in USB mode. Delete the USB connection. Precautions [ Do not use/store the camera in the following places • In an extremely hot, cold or humid place In places such as in a car parked in the sun, the camera body may become deformed and this may cause a malfunction. • Under direct sunlight or near a heater The camera body may become discolored or deformed, and this may cause a malfunction. • In a location subject to rocking vibration • Near strong magnetic place • In sandy or dusty places Be careful not to let sand or dust get into the camera. This may cause the camera to malfunction, and in some cases this malfunction cannot be repaired. [ On carrying Do not sit down in a chair or other place with the ...