The lamp (LT) will continue to flash until the nominal cookingtemperature is reached. It then stays on permanently. When illuminated, this lamp (LV) indicates that steam condensation is switched on. When cooking is completed, steam condensation will start automatically and will remain in operationuntil the pressure in the appliance has been reduced to normal. The lamp (LV) will flash during the cooling phase. 4.4 Shutting down An acoustic signal sounds when cooking is over. This is acknowledged

the pilot flame 2. Loose spark wire; loose igniter nut. 3. Piezo-electric igniter does not generate a spark. 2. Check spark wire connection at the igniter nut and make sure the connection is tight. 3. Replace igniter mechanism (portion with pushbutton). Pilot flame does not stay lighted. 1. Dirty/sooty pilot burner. 2. Low gas supply pressure [less than 6” W.C. for natural gas; (11” W.C. for propane) when all other gas-powered equipment is operating]. 3. Pilot flame too small to heat the thermoc

Per collegare al corpo dell'apparecchio; con l'elemento/unita pannello inclinati all'indietro: 1. Inserite la linguetta sul retro dell'elemento/unita pannello sotto le alette sul corpo dell'apparecchio. 2. Abbassare l'unita sull'apparecchio [A], assicurandosi che l'interruttore di sicurezza sia allineato con le scanalature sul corpo dell'apparecchio [B]. Conexion del mango de la cesta (L370/P107/L484/L485) Debe procurarse que el mango se coloque correctamente y se enclave de forma segura hacia a

03/04B 1 Printed China 8 Text Box: SPECIAL SAFETY INSTRUCTIONS 1. Read all instructions for use carefully and look at the illustrations before you start using the appliance. 2. Do not touch hot surfaces, always use handles or knobs. 3. To protect against electrical shock, do not immerse control panel, cord and plug of this appliance in water or any other liquids. 4. Close supervision is necessary when any appliance is used by or near children. 5. Unplug from outlet (not from receptacle on applia

To read more about GE's ecomagination commitment, visit: ge.ecomagination.com Barcode: 690 5033 11 000 00211 Client: Jarden (Wal*Mart) Project: 169170 Language: EN Date: 12.12.2007 Version: 05 Page: (of 9 pages) IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed, including the following: 1. Read all instructions before using. 2. Do not touch hot surfaces. Use handles or knobs. 3. To protect against electrical shock, do not immerse temperatur

Use of oil/shortening older than the manufacturers recommendations for life of the oil is prone to surge boiling and flash fires. Follow the oil manufacturers guidelines for the life cycle of oil/shortening. Do not open the drain valve or the fill valve while the fryer is under pressure. Serious burns may result. Follow operator instructions regarding effects of surge boiling of over-wet foods and proper load size. This unit may incorporate components that contain Mercury. The use of Mercury rel

Fryer must be installed level. A flexible connector must be installed and secured to the building structure. NOT FACTORY SUPPLIED CAPACITY SHORTENING/OIL: 62 lb (28 kg) maximum ELECTRICAL VOLTAGE PHASE CYCLE/HZ AMPS kW 208-220 (ETL) 3 60 47 17.93 at 208 3 60 45 16.2 at 220 3 60 47.6 18.2 240 (etl) 3 60 43.1 17.93 380-415 at 380 3 50 20.4 15.4 at 415 3 50 25.4 18.3 440-480 (etl) at 440 3 60 40.8 31 at 480 3 60 44.4 37 No cord and plug CLEARANCE REQUIREMENTS_ ba

This is the only way to ensure optimum results and maximum safety. Installation • Before use, check that the appliance has not been damaged during transport. • Remove the appliance from the packaging, including any p.o.s. • Before use, check that the power supply voltage corresponds to the value shown on the appliance rating plate.The appliance must always be connected to a well earthed socket rated at 10A minimum.The manufacturer is not liable for damage caused by inadequate earthing of the app

ReSef Valve 1 HYDRAULIC JACK ASSEMBLY PARTS LIST - HYDRAULIC JACK ASSEMBLY Item No. Part No. Description Qty. 1 SK50605 Mounting Pin, Top Jack 1 2 SK00315 Cap, Jack 1 3 FA30006 Washer 1 4-15 SK00208 Hydraulic Jack Assembly 1 4 SK50578 Piston Rod 1 5 FA20026 Hex Nut, 1/4-20 2 6 FA32008 Lockwasher, 1/4 2 7 SK50575 Cylinder Top 1 8 SK5G596 Wiper Scraper Seal 1 9 SK50711 Spring 1 10 SK50579 Tie Rod 2 11 SK50576 Cylinder 1 12 SK50574 Cylinder Piston 1 13 SK50595 Wiper Seal 3 14 SK50

Visit for a list of service centers near you. (U.S. Only) Enregistrez ce produit en ligne et recevez un numero gratuit de Cook's Illustrated. Visitez Visitez pour y voir une liste des centres de reparation proches de chez vous. (E.-U. uniquement) Registre este producto en linea y reciba un ejemplar gratis de Cook's Illustrated. Visite Visite para ver la lista de centros de servicios cercanos a usted. (Solamente en los Estados Unidos) Instructions for use Keep these instructions Mode d'emploi Con