Votos - 3, Puntuación media: 4 ( )

Fabricar: Homelite Tamaño del archivo: 758.21 kb Nombre del archivo: Idioma del manual:

Keep away from corrosive agents such as garden chemicals and de-icing salts. 3 Abide by all Federal and local regulations for the safe storage and handling of gasoline. Excess fuel should be used up in other 2-cycle engine powered equipment. Page 15 TROUBLESHOOTING IF THESE SOLUTIONS DO NOT SOLVETHE PROBLEM CONTACT YOUR AUTHORIZED SERVICING DEALER. PROBLEM POSSIBLE CAUSE SOLUTION Engine will not start: 1.No spark. 2.No fuel. 3.Flooded engine. 4.Starter rope pulls harder now than when new. 1.Check spark. Remove spark plug. Reattach the spark plug cap and lay spark plug on metal cylinder. Pull the starter rope and watch for spark at spark plug tip. If there is no spark, repeat test with a new spark plug. 2.Push primer bulb until bulb until fuel is visible in the bulb. If fuel is not apparent, the primary fuel delivery system is blocked. Contact a servicing dealer. If primer bulb fills, engine may be flooded (see next item). 3.Remove spark plug, turn blower so spark plug hole is aimed at the ground. Move choke lever to “RUN” and pull starter cord 10 to 15 times. This will clear excess fuel from engine. Clean and reinstall spark plug. Pull starter three times with choke lever at “RUN”. If engine does not start, move choke lever to “CHOKE” and repeat normal starting procedure. If engine still fails to start, repeat procedure with a new spark plug. 4.Contact a servicing dealer. Engine starts but will not accelerate: Carburetor requires adjustment. Turn "L" needle counterclockwise 1/16 turn. If “L” low needle can not be turned counterclockwise, do not force plastic limiter caps. Contact a servicing dealer.See Figure 14. Engine starts but will only run at high speed at half choke: Carburetor requires adjustment. Turn "H" needle counterclockwise 1/16 turn. If “H” high needle can not be turned counterclockwise, do not force plastic limiter caps. Contact a servicing dealer. See Figure 14. Engine does not reach full speed and emits excessive smoke: 1. Oil / fuel mixture is incorrect. 2. Air filter is dirty. 3. Carburetor requires adjustment. 4. Spark arrestor screen is dirty. 1. Use fresh fuel and the correct 2-cycle oil mix. 2. Clean air filter, refer to “Replacing and Cleaning the Air Filter” earlier in this manual. 3. Turn “H” (B) needle clockwise 1/16 turn. See Figure 14. 4. Contact a servicing dealer. Engine starts, runs, and accelerates but will not idle: Carburetor requires adjustment. Turn idle speed screw clockwise to increase idle speed. See Figure 14. NOTE: The carburetor adjustment needle(s) are equipped with plastic cap(s) that prevents counterclockwise rotation from the original factory adjustment. If your unit exhibits specific performance problem(s) where the Trouble Shooting Section recommends a counterclockwise needle adjustment and no adjustments have been made since original purchase, the unit should be taken to a factory authorized service dealer for repair. In most cases, the needed adjustment is a simple task for the factory trained service representative. “L” NEEDLE “H” NEEDLE Fig. 14 IDLE SPEED ADJUSTMENT SCREW Page 16 WARRANTY LIMITED WARRANTY STATEMENT In addition, this warranty does not cover: Homelite Consumer Product, Inc. warrants to the original retail purchaser that this HOMELITE product is free from defect in material and workmanship and agrees to repair or replace, at Homelite Consumer Products, Inc.’s discretion, any defective product free of charge within these time periods from the date of purchase. ¦ ¦¦¦¦¦One year for the following units: UT08110, UT20760, UT10901; ¦ ¦¦¦¦¦Two years for all other Homelite products, if the product is used for personal, family or household use; ¦ ¦¦¦¦¦90 days, if any of the above products are used for product used for any other purpose, such as commercial or rental. This warranty extends to the original retail purchaser only and commences on the date of the original retail purchase. Any part of the HOMELITE product manufactured or supplied by HOMELITE and found in the reasonable judgment of HOMELITE to be defective in material or workmanship will be repaired or replaced by an authorized HOMELITE service dealer without charge for parts and labor. The HOMELITE product including any defective part must be returned to an authorized service dealer within the warranty period. The expense of delivering the HOMELITE product to the dealer for warranty work and the expense of returning it back to the owner after repair or replacement will be paid by the owner. HOMELITE’S responsibility in respect to claims is limited to making the required repairs or replacements and no claim of breach of warranty shall be cause for cancellation or rescission of the contract of sale of any HOMELITE product. Proof of purchase will be required by the dealer to substantiate any warranty claim. All warranty work must be performed by an authorized HOMELITE service dealer. This warranty is limited to ninety (90) days from the date of original retail purchase for any HOMELITE product...

Descargar ahora

Introduzca dos números de la imagen: