Votos - 1, Puntuación media: 4 ( )

Fabricar: Linear Tamaño del archivo: 164.26 kb Nombre del archivo: AP-1.pdf Idioma del manual:

Typically, the AP-1 is used to control a door strike, barrier gate, automatic gate or automatic door operator. The AP-1 contains a high-gain UHF receiver which uses an external antenna to pick up signals from up to 250 feet away. Up to 169 Linear MegaCode Format transmitters and one Model MGT safety edge transmitter can easily be programmed into the AP-1’s memory. The AP-1 will retain its memory, even without power. Two dry contact relay outputs are standard. One relay is the ACCESS RELAY, which triggers for two seconds each time a programmed transmitter is activated. This relay output connects to the pushbutton or radio input of the access device. The second relay is the OBSTACLE RELAY, which triggers for two seconds when an obstacle signal is sent from a Model MGT safety edge transmitter. This relay output connects to the obstacle input of the access device. An OPEN REQUEST input terminal is supplied for hardwire activation of the access device with an external pushbutton. The AP-1 can be powered from 12-24 Volts AC or DC. The Form C relay outputs can switch up to 1 Amp each. An EARTH GROUND terminal is provided as an optional connection for maximum lightning and static protection. Five special utility functions can be displayed by pressing the pound (#) key then the digits 1-5. They display the status of the obstacle transmitter, the number of empty programming locations, the total number of transmitters programmed, first available programming location and firmware version number. The AP-1 can fully supervise the MGT safety edge transmitter. The system monitors the MGT transmitter for hourly status reports, tamper signals and low battery signals. A beep will sound every 5 seconds if a fault occurs and the trouble source can be displayed by pressing pound (#)-1. For a trouble indication, a transmitter must be activated twice to trigger the ACCESS RELAY if a supervisory condition exists on the MGT transmitter. AP-1 FEATURES RECEIVER INSTALLATION ANTENNA INSTALLATION ELECTRICAL CONNECTIONS ® TRANSMITTER NUMBER ACCESS GRANTED POWER EARTH GND OPEN REQUEST ACCESS RELAY OBSTACLE RELAY POWER INPUT 12-24 VAC/VDC SUSPENDED OCCUPIED RADIO N.C. COM N.O. N.C. COM N.O. TRANSMITTER NUMBER ACCESS GRANTED POWER EARTH GND OPEN REQUEST ACCESS RELAY OBSTACLE RELAY POWER INPUT 12-24 VAC/VDC SUSPENDED OCCUPIED RADIO N.C. COM N.O. N.C. COM N.O. MOUNTING SCREWS F-81 CONNECTOR NUT AND LOCKWASHER TRANSFORMER 3-FOOT ANTENNA CABLE WHIP ANTENNA ACCESSPRO MODEL AP-1 RECEIVER TERMINAL STRIP For connection of earth ground, power and open request inputs plus access and obstacle relay outputs. DIGITAL DISPLAY Displays transmitter numbers during operation and programming. Also displays MGT supervision status and system utility information. ACCESS GRANTED INDICATOR SUSPENDED INDICATOR OCCUPIED INDICATOR RADIO INDICATOR NUMERIC KEYPAD Lights when the access or obstacle relay is energized. Lights when a signal is received from a transmitter that has been suspended from use. Lights...

Descargar ahora

Introduzca dos números de la imagen: