Votos - 4, Puntuación media: 4.8 ( )

Fabricar: Invacare Tamaño del archivo: 207.27 kb Nombre del archivo: Idioma del manual:

NOTE: The elevating legrest has two (2) sets of release buttons, one (1) set above the other. Each set will be visible one at a time allowing finer footplate height adjustment. 7. Insert the footplate tube into the front rigging support. 8. Push IN the release buttons and reposition the footplate assembly to the desired height. 9. Ensure that the release buttons fully protrude from holes on both sides of the front rigging support. 10. Rotate cam lock lever DOWN to LOCKED position. 11. Reinstall the swingaway front rigging assembly. Refer to the owner’s manual shipped with wheelchair. 12. Ensure Release buttons are properly seated and FULLY protrude through the adjustment holes before use. 13. Repeat this procedure for the other footplate, if necessary. Bolt-In-Place/Spring Button 4 Part No. 1114831 Front Rigging Kit Part No. 1114831 5 Bolt-In-Place/Spring Button Front Rigging Kit NOTE: Swingaway footrests shown. Footplate Assembly Front Rigging Support Cam Lock Lever Riv Nut Button Head Screw NOTE: Swingaway footrest shown. Front Rigging Support Footplate Assembly Cam Lock Lever Release Button Adjustment Holes Release Buttons Top Spring Button Release Buttons Spring Button Bottom Spring Button Spring Spring Spring FIGURE 2 - INSTALLING THE SPRING BUTTON FOOTPLATE KIT DETAIL “A” DETAIL “B” ELEVATING LEGRESTS/ FOOTRESTS WITH ADJUSTABLE ANGLE FOOTPLATES FOOTRESTS SPRING BUTTON HEIGHT ADJUSTMENT (FIGURE 2) NOTE: This procedure applies to the swingaway footrests and swingaway elevating legrest. 1. Remove the swingaway front rigging. Refer to INSTALLING/REMOVING THE FRONT RIGGINGS in the owner’s manual shipped with wheelchair. NOTE: Lay the front rigging assembly on a flat surface to simplify this procedure. 2. Pull the cam lock lever UP to UNLOCKED position. NOTE: The elevating legrest has two (2) sets of release buttons, one (1) set above the other. Each set will be visible one at a time allowing finer footplate height adjustment. 3. Push IN the release buttons and reposition the footplate assembly to the desired height. 4. Ensure that the release buttons fully protrude from holes on both sides of the front rigging support. 5. Rotate cam lock lever DOWN to LOCKED position. 6. Repeat this procedure for the other footplate, if necessary. 7. Reinstall the swingaway front rigging assembly. Refer to INSTALLING/REMOVING THE FRONT RIGGING in the owner’s manual that shipped with wheelchair. 8. Ensure Release buttons are properly seated and FULLY protrude through the adjustment holes before use. NOTES NOTESNOTESNOTESNOTESNOTES Bolt-In-Place/Spring Button 6 Part No. 1114831 Front Rigging Kit NOTES NOTESNOTESNOTESNOTESNOTES Part No. 1114831 7 Bolt-In-Place/Spring Button Front Rigging Kit MADE IN MEXICO Invacare Corporation USA One Invacare Way Invacare is a registered trademark of Elyria, Ohio USA Invacare Corporation. 44036-2125 Yes, you can. is a trademark of 800-333-6900 Invacare Corporation. © 2003 Invacare Corporation Part No. 1114831 Rev B - 07/03 ...

Descargar ahora

Introduzca dos números de la imagen: