Votos - 4, Puntuación media: 3.5
(
)
)
|
Resumen del manual
~20~ GMP ISO9001 ISO14001 ISO13485 CERTIFIED BATTERIES & BATTERY CHARGING BATTERIES The Powerchair is supplied with 2 x 33/34/36 Ah gel, sealed lead acid, maintenance free batteries. These are fitted under the seat in the center of the Powerchair. For easy handling, Velcro or plastic carrying straps are provided to assist in fitting or removal. The duration of the batteries can be affected by temperature, terrain and weight of the user. The Battery Gauge is a guide on the remaining charge in the batteries. The active user will need to charge the batteries after using approximately more than 30% of battery capacity. As an inactive user, only using from once a week to every other day, the recharge point would be at 50% of discharge. If only using for short distance each day, it is advisable to charge at the end of each week. The state of battery capacity could be referred as Fig.18. Red Bottom Amber Middle Green Top 3 Bars 4 Bars 3 Bars Flashing. Danger, you From 30% -50% Full battery charge. must stop and recharge discharge. the batteries. Failure to Batteries will do so may result in need charging. damage of batteries. Fig. 18 Batteries should be kept fully charged at all times. They must not be left in a discharged state if not using the unit for some time. The batteries should be checked once a month and recharged as needed. BATTERY CHARGING FOR STREAMER-888WAB & WIZZ-888WNL (UNITS EQUIPPED WITH ON-BOARD CHARGER) The batteries supplied with the Powerchair are specially designed and require an automatic battery charger. The battery charger is fitted with an electronic switch that terminates the charge when the batteries are fully charged. WARNING! Only use the original manufacturer approved charger. On-Board battery charger is set beneath the shroud as Fig.19. Charging procedures are as the following: ~21~ GMP ISO9001 ISO14001 ISO13485 CERTIFIED BATTERIES & BATTERY CHARGING 1. Grasp the charging port cover and remove it from the charging port. 2. Plug AC power cord with female connector into the charging port shown as Fig.19. 3. Plug AC power cord with male connector into 110-volt wall outlet. NOTE! The voltage suitable for the charger is different from districts. Please assure to use the correct AC power cord for charging. 4. When charging is complete, grasp the charging port cover and position it in the charging port. 5. The On / Off Charger Indicator will illuminate steady red indicating that the charger is ON. 6. If the On / Off Charger Indicator is “blinking” red, this is abnormal. Unplug AC power cord from the on-board battery charger and wall outlet. Contact your provider as soon as possible. 7. When the On / Off Charger Indicator is off, the charger is off. 8. When the Charging State Indicator is “blinking” green, the batteries are charging. 9. When the Charging State Indicator is steady green, the batteries are fully charged (or as fully charged as their condition will be allowed). At this point, the charger automatically stops charging. 10.If the charger is on and the Charging State Indicator is off, the charger is disconnected. Check that all connections are secure. If Charging State Indicator is still off, unplug AC power cord from the on-board battery charger and wall outlet. Contact your provider as soon as possible. Charging Port with Red Cover On / Off Charger Indicator (Red LED) & Charging State Indicator (Green LED) Fig. 19 ~22~ GMP ISO9001 ISO14001 ISO13485 CERTIFIED BATTERIES & BATTERY CHARGING BATTERY CHARGING FOR STREAMER-888WB & STREAMER-888WSB (UNITS EQUIPPED WITH OFF-BOARD CHARGER) To recharge the Powerchair, connect the charger to the Charging Port at the front of the VSI referred to as (8) in Fig. 14. Switch on the charger. Do not leave the charger plugged into the Charging Port if the charger is not charging. This charger is for indoor use only. Do not expose it to rain or water spray. Do not cover the battery charging vent. One example of indicator light on the charger gives advice as follows: Red – Power on, Amber – Battery charging, Green – Charging complete. Please refer to the LED indicator description based on charging status of the charger. Batteries that are allowed to go below a minimum voltage due to neglect will be unable to be re-charged. The red power light will illuminate but the amber light will not illuminate showing that the batteries will not charge. BATTERY CHARGING FOR JETSTREAM-L/M-888WAL & 888WAM (UNITS EQUIPPED WITH ON-BOARD CHARGER) The batteries supplied with the Powerchair are specially designed and require an automatic battery charger. The battery charger is fitted with an electronic switch that terminates the charge when the batteries are fully charged. WARNING! Only use the original manufacturer approved charger. On-Board battery charger is set beneath the shroud as seen in Fig. 8. Charging procedures are as the following: 1. Pull the AC cord out from the Powerchair and plug male connector into 110-volt wall outlet. NOTE! The voltage suitable for the...
Otros modelos de este manual:Sillas de ruedas - ISO13485 (935.91 kb)
Sillas de ruedas - ISO14001 (935.91 kb)