se debera adquirir a un tercero. . Para los sistemas de bypass con salidas cableadas, los interruptores de desconexion regulados adecuadamente para el (los) circuito(s) de la salida de c.a. deberan ser adquiridos a un tercero. Sakerhetsforeskrifter VIKTIGA SAKERHETSFORESKRIFTER SPARA DESSA FORESKRIFTER DENNA BRUKSANVISNING INNEHALLER VIKTIGA SAKERHETSFORESKRIFTER FA R A Denna UPS-enhet innehaller LIVSFARLIG SPANNING. ENDAST AUKTORISERAD SERVICEPERSONAL far utfora reparationer eller service. Det

.. The device must be in a restricted access area (dedicated equipment rooms, equipment closets, or the like) where the applicable requirements of the device are met. .. The equipment must be in a controlled environment (an area where the humidity is maintained at levels that cannot cause condensation on the equipment, the contaminating dust is controlled, and the steady-state ambient temperature is within the range specified). .. Do not install this equipment at a combustible place. .. This equ

Return the instrument to a qualified dealer for service and repair to ensure that safety features are maintained. II. Connecting the power line 1. Inspect the power selection switch on the back panel, to assure if the selected voltage is the same as environment power voltage. If not, please refer to the notice around the power plug. 2. Before connecting the power supply, please be sure that the switch on the front panel should be in the off position. 3600 Series Programmable Power Supply VERSION

Do Not Substitute Parts or Modify Instrument Because of the danger of introducing additional hazards, do not install substitute parts or perform any unauthorized modification to the instrument. Return the instrument to a qualified dealer for service and repair to ensure that safety features are maintained. II. Connecting the power line 1. Inspect the power selection switch on the back panel, to assure if the selected voltage is the same as environment power voltage. If not, please refer to the n

SAVE SET, BAUDRATE SET, ADDRESS SET, KEY LOCK and CLEAR SAVE DATA function. We will describe the details as follows. 2.3.6.1 Set up the maximum output voltage When you select the MAX VOLTAGE SET function, the LCD will display as: MAX VOLT. = 24.00 VYou can set the voltage value by using the number kaypad or rotating the ROTARY knob. Then confirm NEW= the value by pressing “Enter” button. 2.3.6.2 Set up the maximum output power When you select the MAX POWER SET function, the LCD will display as:

The figure to the right shows the common SwitchModule front panel features. 10.3 Ports SwitchModule port types vary depending on media type and configuration. The following sections describe the port types, along with descriptions of the other front panel components of each SwitchModule. 10.1 LEDs SwitchModule front panels are equipped with LEDs that provide information about module status and traffic activity on the backplane. LED State Indicates Module Status (MOD STAT) Green On SwitchModule p

NOTE: Be sure to connect correspondingly numbered "Data" and "Data & Power" ports. Ethernet Power Supply User s Guide 2-3 Appendix A — Safety Information Safety Information A Read the following safety information before performing any installation, removal, or maintenance procedure on the Ethernet Power Supply. WARNING Warnings contain directions that must be followed for personal and product safety. Follow all directions carefully. WARNING Read the installation instructions in Section 2 before