Votos - 2, Puntuación media: 4 ( )

Fabricar: Thermo Products Tamaño del archivo: 1.02 mb Nombre del archivo: Idioma del manual:

: If you suspect there is a problem with the furnace, its venting system or any other related problem, immediately contact a qualified service agency. 11. Your furnace should be described by the model number and serial number when contacting a qualified heating contractor. This important information is located on the rating plate behind the front door. 12. Should this unit be installed in an attic or other insulated area or if the area is insulated after the furnace is installed, the furnace must be kept free and clear of the insulating material and any fibers that may have come loose. Remember some insulating materials are combustible. : In the event your furnace fails to operate, do not attempt to put the furnace into operation. Contact a qualified heating contractor to service the furnace. 9 All installations and services must be performed by qualified service personnel. III. FURNACE OPERATION A. WARNINGS BEFORE OPERATING FOR YOUR SAFETY, READ BEFORE OPERATING : A fire or explosion may result causing property damage, personal injury or loss of life if you do not follow these instructions exactly. A. This appliance does not have a pilot. It is equipped with an ignition device which automatically lights the burner. Do not try to light the burner by hand. B. BEFORE OPERATING - Smell all around the appliance area for gas. Be sure to smell next to the floor because some gases are heavier than air and will settle on the floor. WHAT TO DO IF YOU SMELL GAS * Do not try to light any appliance. * Do not touch any electric switch, do not use any phone in your building. * Leave the building immediately. * Immediately call your gas supplier from your neighbor’s phone. * Follow the gas suppliers instructions. * If you cannot reach your gas supplier, call the fire department. C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified heating contractor. Force or attempted repair may result in a fire or explosion. B. OPERATING INSTRUCTIONS TO START THE FURNACE: 1. Please read the safety information in this book before operating furnace. 2. Set the thermostat to the lowest setting. 3. Turn off all electric power to the appliance. 4. Remove the louvered door. 10 All installations and services must be performed by qualified service personnel. 5. Turn gas control knob clockwise to “OFF” position. (For gas valves with a switch, move the switch to the “OFF” position). 6. Wait five (5) minutes to clear out any gas. If you then smell gas, STOP! Follow Step B in the previous safety information. Go to the next step if you don’t smell gas. 7. Turn gas control knob counterclockwise to “ON” position. (For gas valves with a switch, move the switch to the “ON” position). 8. Replace front door. 9. Turn on electric power to the appliance. 10. Set thermostat to desired setting. 11. Follow the instructions “To Turn Off Gas To Appliance” and call a qualified heating contra...

Descargar ahora

Introduzca dos números de la imagen: