Votos - 3, Puntuación media: 3.7 ( )

Fabricar: Desa Tamaño del archivo: 162.95 kb Nombre del archivo: Idioma del manual:

2. Attach a Cable Clamp with the “U” on the tail side of the loop leaving a tail approximately 1 to 2 inches. Tighten Clamp Nuts. Make sure no part of the Cable interferes with the Blade. 3. Wrap the other end of the Cable around a secure building joist, truss, or other support near the Fan. Take up all excess slack in the Cable. CAUTION: USE ONLY THE MOUNTING HARDWARE WHICH IS RECOMMENDED FOR USE ON THIS FAN. 4. Attach the remaining Cable Clamp as indicated in Step 2. The excess tail should be trimmed to extend 1 to 2 inches past the Clamp. 5. Check the Assembly to assure the Blade is free of all obstructions. CAUTION: Use of the secondary support cable does not guarantee protection against injury of persons, mounting of both the circulator and cable could fail if subjected to abuse, neglect or improper installation. Figure 1 Exploded View for Detail Large Guard Wires Set Screw Pipe Mounting Flange Inset Figure 2A Threaded Pipe Loctite 243 Non-Oscillating Motor View Motor Mounting Adapter Application Loctite 243 Figure 5 Set Screw Motor Mounting Adapter OPERATING INSTRUCTIONS 1. To Operate: Plug cord into a grounded 120V, 60 Hz outlet. Select desired operating speed with pull cord on the rear of the motor: First pull: High Second pull: Medium Third pull: Low Fourth pull: OFF NOTE: THIS FAN IS VERY HEAVY. Failure to securely hold onto head assembly while adjusting head angle could result in personal injury. 2. To adjust head angle: While holding head firmly, loosen knob under motor (turn counterclockwise). Tilt head to desired position FIRMLY retighten knob under motor. NOTE: Motor Head Adjustment Knob and the On/Off Pull Cord have the same location on oscillating or non-oscillating models. Exploded View for Detail Ceiling Mount Assembly Figure 2B 2 Rev. A 11/07 3 Rev. A 11/07 5084416 5084416 ...

Descargar ahora

Introduzca dos números de la imagen: