Votos - 4, Puntuación media: 3.5
(
)
)
|
Resumen del manual
HEATER READ INSTRUCTIONS CAREFULLY: Read and follow all instructions. Place instructions in a safe place for future reference. Do not allow anyone who has not read these instructions to assemble, light, adjust or operate the heater. HEATSTAR MH35LP MODELMODELHS35LP GAS-FIRED INFRA-RED PORTABLE CONSTRUCTION HEATER DO NOT LEAVE HEATER UNATTENDED OR IN OPERATION WHILE SLEEPING CYLINDER NOT INCLUDED GENERAL HAZARD WARNING: FAILURE TO COMPLY WITH THE PRECAUTIONS AND INSTRUCTIONS PROVIDED WITH THIS HEATER CAN RESULT IN DEATH, SERIOUS BODILY INJURY AND PROPERTY LOSS OR DAMAGE FROM HAZARDS OF FIRE, EXPLOSION, BURN, ASPHYXIATION, CARBON MONOXIDE POISONING, AND/OR ELECTRICAL SHOCK. ONLY PERSONS WHO CAN UNDERSTAND AND FOLLOW THE INSTRUCTIONS SHOULD USE OR SERVICE THIS HEATER. IF YOU NEED ASSISTANCE OR HEATER INFORMATION SUCH AS INSTRUCTION MANUALS, LABELS, ETC., CONTACT THE MANUFACTURER. WARNING: FIRE, BURN, INHALATION AND EXPLOSION HAZARD. KEEP SOLID COMBUSTIBLES SUCH AS BUILDING MATERIALS, PAPER OR CARDBOARD A SAFE DISTANCE AWAY FROM THE HEATER AS RECOMMENDED BY THE INSTRUCTIONS. NEVER USE THE HEATER IN SPACES WHICH DO OR MAY CONTAIN VOLATILE OR AIRBORNE COMPUSTIBLES OR PRODUCTS SUCH AS GASOLINE, SOLVENTS, PAINT THINNER, DUST PARTICLES OR UNKNOWN CHEMICALS. WARNING: NOT FOR HOME OR RECREATIONAL VEHICLE USE ENERCO GROUP, INC., 4560 W. 160TH ST., CLEVELAND, OHIO 44135 • 216-881-5500 04/04 Revision L1 #18675 SPECIFICATIONS MODEL NO. ...............35LP 35LP GAS TYPE................LP-Gas MAX. INLET PRESSURE. ......... 27.5” W.C. MIN. INLET PRESSURE.......... 27.5” W.C. MANIFOLD PRESSURE..........25.5” W.C. Do not exceed the gas supply pressures shown on rating plate for Model 35LP. The maximum inlet gas supply pressure and the minimum inlet gas supply pressure (for purposes of input adjustment) for LP-Gas are shown as follows: WARNING DO NOT EXCEED 27.5” W.C. (1 psi) INLET PRESSURE TO HEATER. VENTILATION WARNING THIS APPLIANCE IS UNVENTED AND MUST BE USED ONLY IN A WELL VENTILATED AREA. The flow of combustion and ventilation air must not be obstructed. DO NOT use in a tightly enclosed area. Any combustion process requires and consumes oxygen, and may produce carbon monoxide. This heater must be operated with adequate ventilation. Two openings directly to the outdoors must be provided, one low and one high, preferably on opposite sides of the area to be heated. Each of these openings must provide at least three square inches of combustion air-intake area and exhaust outlet area for every 1000 BTUs per hour of heater input rate in order to complete the combustion/ventilation process. Provide additional ventilation for any additional fuel-burning appliances and/or additional occupants. CLEARANCE (Minimum clearances to combustible materials) MODEL NO. BTU/HR RATING TYPE GAS NORMAL OPERATING POSTION CLEARANCES TO COMBUSTIBLES NATURAL LP & NG TOP SIDES BACK FRONT 35LP 35,000* VERTICAL 40” 40” 0” 54” *Tank size and tank temperature can directly affect BTU output CONTENTS Installation Instructions.................................................... 3 Location .......................................................................... 3 Piping .............................................................................. 3 Operating Instructions ..................................................... 4 Lighting and Shut Down .................................................. 4 Maintenance Instructions ................................................ 5 Replacement Parts List ..................................................... 6 Service and Parts Ordering Information ........................... 8 FOR YOUR SAFETY Do not use this heater in a space where gasoline or other liquids having flammable vapors are stored or used. The heater is designed and approved for use as a construction heater under ANSI Z83.7 / CGA 2.14 - 2000 We cannot anticipate every use which may be made of our heaters. CHECK WITH YOUR LOCAL FIRE SAFETY AUTHORITY IF YOU HAVE QUESTIONS ABOUT APPLICATIONS. Other standards govern the use of fuel gases and heat producing products in specific applications. Your local authority can advise you about these. This appliance is intended to be used primarily for the heating of buildings under construction, alteration or repair. THE STATE OF CALIFORNIA REQUIRES THE FOLLOWING WARNING: WARNING Combustion by-products produced when using this product contain carbon monoxide, a chemical known to the State of California to cause cancer and birth defects (or other reproductive harm). Enerco Group, Inc. | Gas-Fired Infra-Red Portable Construction Heater 2 Operating Instructions and Owner’s Manual GENERAL INFORMATION A. Your Enerco Technical Products portable gas-fired infra-red heater comes fully assembled and is tested at the factory for proper gas and input as stated on the nameplate. B. Each heater is equipped with a 100% safety shutoff, push button valve which will automatically stop the flow of gas in the event the heater fails to...