Votos - 2, Puntuación media: 5
(
)
)
|
Resumen del manual
The gasket surface must be clean, free of irregularities and seated firmly. Clean Lower Control Compartment Keep control compartment clean by vacuuming or brushing at least twice a year. More frequent cleaning may be required due to excessive lint from carpeting, bedding materials, etc. It is important that control compartments, burners andcirculatingairpassagewaysoftheappliance be kept clean. Clean Logs And Burner Carefully remove the logs (use care when handling the fiber logs, as they become quite fragile after curing). Vacuum out any foreign matter (lint, carbon, etc.) on the burner. Ensure the burner ports are “open.” Remove any carbon deposits from the under side of the logs using a vacuum cleaner, or a soft bristled brush (i.e. paint brush). Note: Improper positioning of logs can create carbon build-up and will alter the performance of the appliance. Replacing Logs If the logs become damaged by accident or improper handling and need replacement, use only the proper replacement logs from manufacturer (see Page 23 for ordering information). Re-Install Embers, Logs and Volcanic Stone Carefully follow placement instructions on Page 12. All logs should fit onto corresponding pins and/or log stoppers. This will ensure a proper flame and safe combustion. Inspect Wiring Refer to wiring diagrams on Page 15. CAUTION: Labelallwirespriortodisconnection when servicing controls. Wiring errorscancauseimproperanddangerous operation. Verify proper operation after servicing. ATTENTION: Au moment de l'entretien des commandes, etiquetez tous les fils avant de les debrancher. Des erreurs de cablage peuvent entrainer un fonctionnement inadequat et dangereux. Inspect and clean all wire connections. Ensure that there is no melting or damage. Inspection should include: • Terminals at the Valve • OFF/ON Switch • (Optional Control Switch) Wall Thermostat, Remote Control or Remote Wall Switch Kit Inspect Burner Flame Appearance Ensure that the burner flame appearance resembles the flame shown in Figures 5 and 9 on Pages 12 and 13 and as described in Flame Appearance and Sooting on Page 13.The Homeowner must contact a qualified service technician at once if any abnormal condition is observed. Small Area Paint Touch-up Only use a factory supplied paint kit for touch-ups. Paint is available at your local authorized LHP dealer. Never attempt to paint a hot fireplace. If the surface later becomes stained or marred, it may be lightly sanded and touched up with spray paint. Front Glass Enclosure Panel, Removal and Installation Front Glass Enclosure Panel, Removal and Installation• Do not attempt to substitute the materials used on this door, or replace cracked or broken glass. • Handle this glass with extreme care! Glass is susceptible to damage Do not scratch or handle roughly while reinstall ing the glass door frame. • The glass door of this appliance must only be replaced as a complete unit as provided by the manufacturer. Do not attempt to replace broken, cracked or chipped glass sepa rately. • Do not attempt to touch the front enclosure glass with your hands while the fireplace is in use. WARNING Do not operate appliance with the glass frontremoved,cracked or broken. AVERTISSEMENT Ne pas utiliser l'appareil si le panneau frontal en verre n'est pas en place, est craque ou brise. WARNING Any safety screen or guard rem...
Otros modelos de este manual:chimeneas - SDV SDVPF-N-B (2.24 mb)
chimeneas - SDV SDVPF-N-B (2.24 mb)
chimeneas - SDV SDVPF-N-B (2.24 mb)
chimeneas - SDV SDVST-N-B (2.24 mb)