Votos - 4, Puntuación media: 4.5
(
)
)
|
Resumen del manual
Tighten compression fitting if necessary. b. Turn on power to the Brewer. The Brewer will automatically start filling. After 6 minutes the filling cycle will stop and the thermostat should be turned clockwise to the full ON position. Allow approximately 20 minutes for the brewer to reach full brewing temperature (197'-203'). When the GREEN READY LIGHT comes ON the brewer is ready to brew the next batch of coffee. NOTE: Before proceeding further, make sure the sample Filter pack has been removed from the funnel. CHECKING BREW CYCLE OUTPUTS. The BC-Series brewers are factory preset to deliver the proper amount of brewing water for the 12 cup, 24 cup and 36 cup brew cycles. Nevertheless, it is a good practice to check the output levels prior to brewing the first batch of coffee. BC1 and BC2: Full 36 cups (3 decanters) per brew cycle with a 20% by-pass. BC120 and BC240: Selectively 12 cups (1 decanter) or 24 cups (2 decanters) per brew cycle. No by-Pass. BC301 and BC302: Selectively 12, 24 and 36 cups per brew cycle with a 20% by-pass for the 36 cup cycle only. TO START A BREW CYCLE: Turn Warmer Switch to the ON position. The Warmer Switches also double as CYCLE STOP switches. With Funnel and Carrier in place activate GREEN BREW switch. On BC120, BC240, BC301 and BC302 brewers first activate brew switches marked 12 cups and then check output. Do the same with the 24 cup brew switch and the 36 cup brew switch for the BC301 and BC302 units. NOTE: 12 cups equal 1 full decanter. If necessary adjust the timer(s) to increase or decrease output levels. See Timer adjustments. COFFEE BREWING INSTRUCTIONS Place filter paper into brew basket and add finely ground coffee as per chart below: MODEL# CUPS BREWED RECOMMENDED COFFEE AMOUNT TOTAL BREW TIME Single BC120 12 / 24 Cups 2 oz./ 4 oz. 3.0 / 4.5 Minutes Single BC240 12 / 24 Cups 2 oz./ 4 oz. 3.0 / 4.5 Minutes Single BC1 36 Cups 6 oz. 6.0 Minutes Twin BC2 2 x 36 Cups 2 x 6 oz. 6.0 Minutes Single BC301 12 / 24 / 36 Cups 2 oz./ 4 oz./ 6 oz. 3.0 / 4.5 / 6.0 Minutes Twin BC302 2 x (12 / 24 / 36 Cups) 2x (2 oz./ 4 oz./ 6 oz.) 2x (3.0 / 4.5 / 6.0 Minutes) Insert brew funnel back into brewer and position empty carriers under brew funnels. With Warmer Switches on (lit), depress Green Brew Switches. Total brew time will vary according to cups selected. After funnel stops dripping, remove and empty funnels. Warning: Remove Brew funnel ONLY after it has stopped dripping. 4 ADJUSTMENTS 1. BY-PASS FLOW VALVE ADJUSTMENTS Depending on the model number, the BC Brewers have been factory set to brew 12, 24 and/or 36 cups of coffee, with the BY-PASS adjusted for a 20% BY-PASS flow of brewing water for the 36 cup, brew output only. Since water hardness, the brand of coffee, and the length of brew time are important factors in final drink taste, it may be necessary to adjust the percentage of BY-PASS. In general, the more ground coffee used for each brew, the higher the percentage of BY-PASS. Proceed as follows to adjust BYPASS: Place empty carrier without cover under brew funnel. a. Pull brew funnel out 3 inches, exposing BY-PASS outlet behind funnel. b. Activate warmer/cycle stop switch. Switch will be lit. c. Hold measuring cup under BY-PASS outlet and activate Green Brew Switch. After 15 seconds, push warmer/cycle stop switch to stop cycle. d. Measure ounces of water in cup and ounces of water in carrier. Divide ounces in cup by total volume dispensed (add ounces in cup and carrier) to get the BY-PASS ratio. e. To get more BY-PASS, turn slotted adjustment screw in spray-head adjuster Counter-ClockWise. Turning adjuster screw clockwise will decrease the BY-PASS flow. See figure below. NOTE: The BY-PASS valve is activated only when the 36 cup cycle is selected. The BC301 and BC302 units do not use the BY-PASS when brewing for 12 and 24 cups. The BC120 and BC240 models only brew for 12 or 24 cups and therefore do not have the BY-PASS. DUAL BYPASS VALVE ADJUSTMENT SCREW [2] 5 6 REMOVE JUMPER FOR 240V 2. TIMER ADJUSTMENT PROCEDURE Remove the top cover to access the brew timer(s). To INCREASE output: turn timer knob a small increment CLOCKWISE. To DECREASE output: turn timer knob a small increment COUNTER-CLOCKWISE. Check output level in carrier. BCI, BC2 BC120, BC2...
Otros modelos de este manual:Cafeteras - BC1 (2.09 mb)
Cafeteras - BC2 (2.09 mb)
Cafeteras - BC240 (2.09 mb)
Cafeteras - BC301 (2.09 mb)