Votos - 2, Puntuación media: 5 ( )

Fabricar: Daewoo Tamaño del archivo: 260.31 kb Nombre del archivo: Idioma del manual:

2. Avoid the unit being exposed to direct sunlight. Keep direct sunlight from the room. 3. Do not leave doors and windows open. • FAN & COOLING CONTROL The Fan Control Selector Switch has six positions. Choose one of the speed settings by rotating the fan control Selector Switch to the appropriate position. CAUTION When the air conditioner has been performing its cooling operation and is turned “OFF” or set to the ‘FAN” position, wait at least 3 minutes before resetting to the cooling operation. OFF Select this setting for stop all operation of air conditioner HIGH FAN Select this setting for high air circulation without cooling. LOW FAN Select this setting for quiet air circulation without cooling. LOW COOL Select this setting for cooling operation with LOW FAN. MED COOL Select this setting for cooling operation with MEDIUM FAN. HIGH COOL Select this setting for cooling operation with HIGH FAN. • TEMPERATURE CONTROL Choose a temperature settings by rotating the knob of thermostat to the appropriate position 10 • The Thermostat automatically starts and stops cooling operation in order to keep the room temperature at a proper level, and this results in efficient use of power and economical cooling. • Turn clockwise for a cooler room temperature. • Turn counter-clockwise for a warmer room temperature. NOTE Setting the control at the coldest extreme of the temperature range will not cool the room any faster. Usually the midpoint is a good starting position. If the room temperature is not satisfactory after a reasonable period of time, adjust the temperature control to a lower or higher setting. GENERAL INFORMATION • CHANGING AIR FLOW DIRECTION Air flow deflectors divert air from center flow to left or right and up or down. Adjust deflectors for desired air flow pattern. AUTO SWING (DWC-100CS, DWC-121CS, DWA-122CS, DWA-150CS, DWA-151CS) When the auto louver switch is turned to “ON” position, the vertical louvers AUTO SWING automatically move right and left. Thus, you can obtain comfortable cooling. The vertical louvers may be stopped at any position when the auto louver ON / OFF switch is turned off. • AIR FLOW AROUND UNIT Check in door grill and outdoor louvers for air flow obstructions. Do not block air flow to and from unit. The outdoor coil should be checked and periodically cleaned for debris that may collect and block unit air flow. If air flow is obstructed or deflected back into unit, the compressor may cycle on and off rapidly, causing early compressor failure. • DRAIN HOLE AND WATER DRIPPING OUTSIDE Locate drain hole at the rear or on the bottom of unit. Water in base pan is picked up by the fan blade and thrown onto the warm outdoor coil where it evaporates. The air conditioner must be installed level or tilted slightly to the outside for proper water disposal. On exceptionally hot and humid days the air conditioner may permit excess water to pass thru rear drain hole or overflow. This should be considered normal. • HOW TO INSTALL THE D...

Descargar ahora

Introduzca dos números de la imagen: