Votos - 2, Puntuación media: 4 ( )

Fabricar: Craftsman Tamaño del archivo: 220.94 kb Nombre del archivo: Idioma del manual:

It means attention.q! Your safety is involved. These included parts make up the the fence and rails accessory 9P9993. Fasteners are shown actual size. 1. Fence Rails 2. A, Fence ............................................................. 1 A. Front rail end cap ........................................... 2 B. Screw (1/4-20 x 3/8) ...................................... 2 B. Screw for end caps (5/32-32 x 1/2 in.) ........... 4 C. Fine Adjustment Knob ................................... 1 C, Rear rail end cap ........................................... 2 D. Front rail ......................................................... 1 E. Rear rail ......................................................... 1 © O A. B.C. A. B.C. Fig. 1 2 REMOVING THE SWITCH AND RAILS • Remove the front rail end caps. • Under the front rail, loosen the switch screws and slide the switch off of the rail. See Figure 2. Note: Do not remove the switch screws completely. Loosening the screws will allow you to slide the switch off the front rail and the switch will be ready to install on the new front rail, FRONTRAIL _ TABLE EXTENSION SWlTCHSCREW SWITCH SQUARENUT L._ Fig. 2 SLOTFORBOLT TABLEEXTENSION REARRAIL __ SQUAREHEAD BOLT HEXNUT FLATWASHER Fig. 3 • Remove the rear rail end caps. • Under the table, loosen all of the hex nuts on the square head bolts that hold both front and rear rails. See Figure 3. Note: Do not remove the hex nuts completely. Loosening the nuts will allow you to slide the rails off the table and the square head bolts will be ready for the new rails. • Carefully slide the rails off of the bolts and the table. INSTALLING THE REAR RAIL • Position rail so that the right hand edge extends A'_ WARNING: Front and rear rails must be carefully aligned to reduce the risk of kickback, which can cause serious injury. • From the carton, remove the rear rail and the following hardware: Right and left end caps for rear rail 2 screws (5/32-32 x 1/2 in.) for end caps Note: The square head bolts, washers, and hex nuts shown at the top of figure 3 should still be on the table saw. If you mistakenly removed them, put them back on the table. Do not tighten. • Carefully slide the rail onto the square head bolts. SQUAREHEAD BOLT HEXNUT FLAT WASHER Fig. 4 2-1/2 in. beyond the table extension. Note: Instructions are given from the operator's position in front of the saw. • Push the rail against table and tighten each hex nut with a 12 mm wrench. If the rail jams or does not slide easily over the bolts, re-align the table extensions according to the instructions in the table saw owner's manual. Note: Make sure there are no gaps between the rail and edge of table or extensions. • Put the end caps on the rail ends. Insert the screws and tighten with a phillips screwdriver. SCREW 4 INSTALLING THE FRONT RAIL • Locate the front rail and the following hardware: Right and left end caps for front rail 2 screws (5/32-32 x 1/2 in.) for end caps • Set aside the end caps and two screws until the ...

Descargar ahora

Introduzca dos números de la imagen: