Votos - 3, Puntuación media: 3.7 ( )

Fabricar: Craftsman Tamaño del archivo: 220.94 kb Nombre del archivo: Idioma del manual:

_I, WARNING: Place the switch out of the immediate work area to avoid accidentally turning it off during operation. • Slide the switch assembly to a convenient position, leaving ample clearance for the handwheel. Tighten securely with a screwdriver. • Attach the front rail end caps and screws with a phillips screw driver. See Figure 11. FRONTRAIL \ P TABLE EXTENSION SWITCHSCREW SWITCH ASSEMBLY Fig. 10 ENDCAP SCREW Fig. 11 ALIGNING THE RIP FENCE AND FRONT RAIL The rip fence scale indicator is installed on the right side of the rip fence but can be removed and reinstalled on the left side if needed. If a cutting operation requires placing the rip fence on the left side of the blade, and you find relocating the indicator necessary, simply unscrew and re-attach it. • Hook the back of the rip fence over the rear rail. See Figure 12. Lowper the front of the rip fence into the groove on the front rail. See Figure 13. • Slide the rip fence back and forth. It should move freely with about 1/16 in. clearance below the rip fence. If it doesn't, loosen the nuts holding the front rail and adjust the rail up or down. See Figure 6. RIPFENCE • Remove the rip fence and repeat on the other side of the blade. When the fence rides smoothly, tighten all rail hex nuts with a 12 mm wrench. • Push in the micro-adjust knob and turn it. The gear on the shaft assembly will engage the rack teeth on the rack and will move the fence assembly left or right. Push down on the rip fence handle to lock the rip • fence in place. TO INSTALL INDICATOR ON LEFT SIDE REARRAIL HOOKOVER REARRAIL HERE Fig. 12 RIP FENCEHANDLE Fig. 13 CHECKING RIP FENCE AND. BLADE ALIGNMENT The rip fence is self-aligning but should be checked before first use. _. WARNING: Failure to align the rip fence to the blade can cause jams and kickback, resulting in serious personal injury. • Slide the rip fence to the miter gauge groove, which is parallel to blade. Do not lock the rip fence. • Place a framing square against the blade, with the long end under the rip fence at the front. See Figure 14. Note the distance. • Move the square to the back and measure the length from other end of the fence. See Figure 15. • If the distances are different, loosen the four screws around the rip fence handle with a 6 mm hex key. Alternate the order (remove the screw opposite, not next to the first one). See Figure 16. • Hold the fence handle against the front rail and align the rip fence with the blade. • Retighten the screws in alternating order and check the alignment. • Repeat until the rip fence is aligned. MITERGAUGEGROOVE BLADE RIPFENCE MITERGAUGEGROOVE FRAMING SQUARE ADJUSTMENTSCREWS RIPFENCE Fig. 15 ADJUSTMENT SCREWS(4) RIPFENCE HANDLE Fig. 16 MITERGAUGE GROOVE Note: To insure proper self alignment when positioning rip fence, push sides of scale indicator housing against front rail before locking rip fence handle. Fig. 14 8 ...

Descargar ahora

Introduzca dos números de la imagen: