Votos - , Puntuación media:
(
)
)
Fabricar: Hobie
Tamaño del archivo: 253.11 kb
Nombre del archivo: OutSailKit.pdf
Idioma del manual:
El documento se está cargando, por favor, espere
 |
El documento se está cargando, por favor, espere
Resumen del manual
Follow these simple instructions and you'll be out and sailing in minutes. If you are using this kit for your Tandem Mirage, ignore steps 5 and 6 shown here and consult your conversion kit manual Step 4: Tie in the batten (Note: Be sure that when tying, the batten is pulled snug into the sail). TIP: A little tape around the Step 1: Connect mast poles together. * f Feed the line through the hole in batten head. Next, feed the line through ring on the opposite side of sail and pull back snug into the Step 5: Insert mast into kayak and attach stretch cord to hook at the of the mast. Step 6: Run the mainsheet from the sail side, through the rear pad-eye, and up through the right clip on your seat. This configuration allows you ' to steer with your left hand and control the sail with your right. TIP: 16 the end of the main sheet in a knot after sliding through the seat clip. This helps keep the end of the line from falling into the water if you should happen to lose your grip. Sailing Tips Sailing with Hobie's patented MirageDrive Mechanism adds a whole new dimension to sailing. For the best performance, continue pedaling while sailing. You will notice that with very little effort pedaling, the kayak will respond with a surprising amount of performance. If you sail without pedaling, the pedals should be together. This will align the fins in the straight down position so they will act as a daggerboard to reduce side slip. Optimum Wind The sail will work even in very light wind because of the benefit of pedaling to create apparent wind. Optimum wind strength is between 4 to 10 MPH. As the wind speeds exceed optimal range, the kayak will become more difficult to control. When there is too much wind, take the sail down, roll it up, and stow it on the right side of the cockpit. The bungee hook in the cockpit can be stretched over the rolled up sail and hooked to the paddle retainer bungee on the side of the kayak. Trim the Sail Pull in the "mainsheet" until the sail stops "luffing" (the sail will fill with wind and the wrinkles will disappear). This ammount of trim will work, but for optimum performance you should try to get the "telltales" (the black ribbons attached to the sail) flowing back on both sides of the sail. Dancing Over trimmed Under trimmed Correct Trim Sheet out (let the sail out) or head up (turn into the wind or turn right). Sheet in (pull the sail in) or head down (turn away from the wind or turn left). Sail is trimmed with both telltales flying straight back. Points of Sail "Close hauled": The kayak will heel or lean most when sailing close hauled. Shift your weight to the side of your seat to counter the lean of the kayak. Be ready to let the sail out to reduce the amount of heel in stronger wind. Starboard Port Tack Tack "Running": Sailing downwind does not take advantage of the aerodynamic shape of the sail. "Reaching": This is the fastest point of sail. WIND t Tacking Tacking a sailboat is the act of changing the direction of the boat from sailing close hauled with the wind on one side, coasting through the eye of the wind, and then sailing with the wind coming from the other side. This maneuver can be difficult for beginning sailors but with the Hobie MirageDrive you simply pedal through the tack and resume sailing on the new heading. Since you can not sail directly into the wind, you must sail in a zig zag course to make it directly upwind. Of course, with the Hobie MirageD rive, you can cheat and just point the kayak where you want and pedal! Enjoy Sailing your kayak will open up new experiences and broaden your opportunities to go further and faster with less physical effort. Be sure to learn the right-of-way rules and when in doubt, give way to others. Have fun and stay safe. Running www.hobiecat.com...