Votos - 2, Puntuación media: 4 ( )

Fabricar: Moen Tamaño del archivo: 234.14 kb Nombre del archivo: Idioma del manual:

1. Rotate the handle counterclockwise to the stop, let the water run for several minutes to purge cool water from the hot water supply line, check the hot water temperature. 2. Rotate handle clockwise to off. Remove handle parts, see "Disassembly" and temperature limit stop, rotate the stop clockwise to decrease (counterclockwise to increase) maximum hot water temperature and reinstall into key stop. 3. For handle styles A & B replace handle, for style C replace handle adapter, do not use handle screws. 4. Rotate the handle or handle adapter counterclockwise to the stop, recheck maximum hot water temperature. 5. Repeat steps 2,3 & 4 until desired maximum temperature is achieved. Install handle parts, see Handle Attachment under "Trim" on following page. KEY STOP TEMPERATURE LIMIT STOP ROTATE LIMIT STOP CLOCKWISE TO REDUCE FULL HOT POSITION Trim MAKE SURE ALL WATER SUPPLIES ARE OFF TO INSTALL TRIM AFTER ROUGH-IN Slide the flange onto the long end of the shower arm. Wrap both ends of shower arm with thread seal tape and screw long end of shower arm into pipe ell inside the wall. Do not install the showerhead. Install tub spout (see page 2). Remove screw holding plaster ground and stop tube guard in place and discard. Temporarily install handle. Turn on water, pull up on tub spout diverter knob and flush the shower riser for 15 seconds. Install showerhead and check system for leaks. If there are no leaks, turn OFF water and remove handle and limit stop. Install escutcheon plate with two screws provided. Mount with the escutcheon notch UP. Install limit stop(see temperature limit stop section). The notched flat on the cartridge stem must point DOWN when mounting handle. Handle Attachment : TEMPERATURE LIMIT STOP ESCUTCHEON SCREWS (2) SHOWERHEAD SHOWER ARM NOTCH CC CONNECTIONS ESCUTCHEON TUB LOOKOUT NIPPLE ForhandlestyleA+B.Mounthandleonthestemandreplacehandlescrewtightly. SPOUT Snap handle insert or plug button in place on the handle. For handle style C . Mount handle adapter on the stem and replace handle screw tightly. Mount handle on handle adapter and replace set screw. TO REMOVE STOP VALVE Always turn water supply OFF before disassembly (see disassembly). Removal of stop valve: 1. Remove handle parts (see disassembly) and escutcheon. 2. Using snap ring pliers, remove retaining ring from valve body. 3. Grip stop valve stem with pliers and rotate slightly to remove from valve body. Re-Installation of new stop valve: 1. Check to be sure that stop valve stem is fully seated in plug. 2. Insert stop valve until fully seated beyond retaining ring groove in valve body. 3. Using snap ring pliers, place retaining ring in valve body, making sure that ring is fully seated. 4. Check orientation of stop valve for water flow. (Stop is in the off position when screwdriver slot is vertical). 5. Turn water supply on. Not for use with M...

Descargar ahora

Introduzca dos números de la imagen: