Votos - 2, Puntuación media: 4 ( )

Fabricar: Philips Tamaño del archivo: 627.66 kb Nombre del archivo: Idioma del manual:

Sinto Amplificadores, Decks de Cassettes, Magnetófonos. Ecualizadores.Torname-sas, Cajas Acústicas, Radios Combinados y Auto Radíos. English SUPPLY @> RECORDING Battery supply • Open the battery compartment (fig. 2) and insert as indicated six batteries, type R20, UM1 or D-cells. • Remove the batteries if exhausted or if they will not be used again for a long period. The battery supply is switched off when the set is connected to the mains. When changing over to battery supply, pull out the plug from the MAINS socket. Mains supply • Check if the mains voltage as shown on the type plate (on the base of the set) corresponds to your local mains supply. If it does not, consult your dealer or service organisation. lithe set is equipped with a VOLTAGE selector, setthis selector to the local mains voltage. • Connect the mains lead to the MAINS socket and the wall socket. The mains supply is now switched on. • To disconnect the set from the mains completely, withdraw the mains plug from the wall socket. RADIO RECEPTION • Set the RADIO-TAPE/OFF selector to RADIO. • Adjust the sound with the VOLUME control. You may connect stereo headphones with 3.5 mm plug to socket fj. The loudspeakers are then muted. • Select the wave band using BAND selector. • Tune to a radio station using TUNING knob. (SWand LWnot on all versions). - For FM, pull out the telescopic aerial. To improve FM-reception, incline and turn the aerial. Reduce its length if the FM-signal is too strong (very close to a transmitter). - For AM/MW and LW (Medium and Long Wave), the set is provided with a built-in aerial, so there is no need to use the telescopic aerial. The aerial can be directed by turning the whole set. - For Short Wave (SW), the telescopic aerial must be pulled out and placed in the vertical position. To improve SW-reception, vary the length of the aerial. • When the BAND selector is in position FM STEREO and the FM STEREO indicator lights up, you are receiving a FM-stereo transmitter. A disturbing noise, clue to a weak FM-stereo signal, can be suppressed by setting the BAND selector to FM MONO. The FM STEREO indicator will then go out and you will hear (and record) the FM programme in mono. • The set is switched off if RADIO-TAPE/OFF selector is in position TAPE/OFF and the recorder buttons are released. CASSETTE RECORDER Copyright: Recording is permissible insofar as copyright or other rights of third parties are not infringed. Fast winding and rewinding: Press fast forward wind F.FWD « or REWIND ►► button. To stop, press STOP ■. Safeguarding a cassette against erasure: Keep the cassette side to be safeguarded in front of you (fig. 4) and break out the left tab. Now, recording on this side is no longer possible. • Press EJECT ■ to open the cassette holder. • Insert the cassette (fig. 3). For recording you must use a NORMAL cassette (IEC type I) on which the tabs (fig. 4) are not broken out. At the very beginning of the tape, no recording will tak...

Descargar ahora

Introduzca dos números de la imagen: