Votos - 1, Puntuación media: 3 ( )

Fabricar: Electrolux Tamaño del archivo: 894.87 kb Nombre del archivo: Idioma del manual:

The presence of this system means that the drain pipe can be connected directly to the mains drainage system or routed to a floor gulley with grating. The flexible drainage hose or rigid pipe can be directed to the side or rear of the appliance if the oven is not positioned against a wall; this line must not be directed towards the front of the appliance to prevent interference with roll-in grid racks. The drainage pipe internal diameter must be no smaller than the oven drain outlet (1 1/4"), no longer than 3 feet (1 metre) and must resist temperatures of up to at least 212°F (100°C). Avoid restrictions in the case of flexible hose pipes, do not fit elbows on metal pipes anywhere along the drainage line. Also avoid horizontal sections in which water might collect (minimum gradient 5%). WARING: BLOCKING THE DRAIN IS HAZARDOUS. C - Oven drain C1 - Safety outlet Important: - Do not obstruct the safety outlet C1. - Do not connect the safety outlet C1 to the drainage system. Note: If water comes out of the AIR-BREAK (safety outlet C1) this means the drain C is blocked. Any elimination of the obstruction must be carried out by specialised technical personnel. 15 USA 5938 035 01 - OVEN level C - Connect drain fitting “C” to a drain pipe of the same diameter which is between 0.5 and 3 metres in length and is resistant to temperatures of at least 100°C. The drain pipe must be siphoned (height 80 mm) to an open drain “O” (“Air-Break”) or floor grating (see Fig. 12b) in order to prevent any back-flow from the sewage system from reaching the piping inside the oven or oven chamber. Check the hoses and elbows on metal pipes for kinks or pinching along the entire drain line and make sure the drain line has a minimum gradient of 5° to prevent water from collecting inside the system. Important: The drain system must be installed so that any vapours from the open drain do not enter the aeration vents under the appliance. OK min 5° C AIR-BREAK T max = 100°C max 3m 0,08 m min 0,5m O C AIR-BREAK O KO 5. SAFETY DEVICES The appliance is fitted with the following safety devices: - Fuses (see electrical circuit diagram) located behind the control panel. To change a fuse unscrew and remove the retainer cap and replace the blown fuse with an identically rated component; the fuse rating value is specified on the relative dataplate. - Oven chamber safety thermostat with manual reset, located behind the control panel; when this device trips, convection heating power is disconnected. Notice: CONTACT YOUR AUTHORIZED SERVICE COMPANY TO PERFORM MANINTENANCE AND REPAIRS. - Automatic reset thermal protection inside the cavity fan motor: this device trips in the event of overheating of the cavity fan motor; this cut-out protects the appliance by disconnecting the power supply to the main PC board and an error message is display EFUN. 6. OPERATION CHECK - Switch on the appliance in accordance with the following section "Instructions for use". - With the aid of the Instruction Booklet, explain operation, routine maintenance, and cleaning to the user. Important: - Exercise due care since certain areas of the oven exterior become hot during use. - Do not cover the exhaust outlets on top of the appliance. 7. SERVICING All components requiring routine maintenance may be easily reached by opening the control panel, removing the left side panel, or removing the rear panel. Danger: Live voltage is present with panels removed and unit switch on. ...

Descargar ahora

Introduzca dos números de la imagen: