Iniciar sesión:
Votos - 3, Puntuación media: 4 ( )

Manual de usuario Crate Amplifiers, modelo Solo

Fabricar: Crate Amplifiers
Tamaño del archivo: 554.47 kb
Nombre del archivo: 699ebc3f-6079-4491-9fb4-dedc71aba00d.pdf
Idioma del manual:enesde
Enlace gratuito para este manual disponible en la parte inferior de la página



Resumen del manual


Cuando coloque las baterías asegúrese de observar la appropiada polaridad de las mismas. Después de instalar las baterías, vuelva a colocar la cubierta y asegúrela con los tornillos. POWER AMPLIFIER SECTION: Rated Power & Load: 15W RMS into 3.2 ohms Power @ Clipping: (Typically (a) 1 kHz. 3.2 ohms) (Using external Power Pack @120 VAC or external regulated + 12 VDC Source): 15W RMS (a) 5% THD (Using internal “New" batteries @12 VDC): 10W RMS @ 5% THD Frequency Response: +0. -3 dB. 80 Hz to 10 kHz @ 1 watt into 3.2 ohms Total Harmonic Distortion: Less than 0.3%. 100 mW to 10W RMS. 80 Hz to 10 kHz. 3.2 ohms Typically below 0.2% Power Consumption (External Power Pack): 40 watts @ 120 VAC. 50/60 Hz Power Consumption (Optional 12V Adaptor): 12-17 VDC. Negative Ground 24 watts @12 VDC. 2 ADC SOLO™ SPECIFICATIONS Battery Complement: Eight Si-ze ‘D’. 1.5 Volt (ANSI-L90) (Alkaline Type Recommended) PREAMP SECTION: The following specs are measured @ 1 kHz with the Low and High EQ controls set @ 5 Nominal Level is with Gains @ 5 Minimum Level is with Gains @10 Low Z Microphone Input: Input Impedance: Low Z. 3.3K ohms Nominal Input Level: -36 dBV. 15 mV RMS Minimum Input Level: -54 dBV. 2 mV RMS Maximum Input Level: +6 dBV. 2.0V RMS High Z Microphone Input: Input Impedance: High Z. 33K ohms Nominal Input Level: -16 dBV. 150 mV RMS Minimum Input Level: -34 dBV. 20 mV RMS Maximum Input Level: +26 dBV. 20V RMS High Z Auxiliary Input: Input Impedance: Very High Z. 2.2M ohms Nominal Input Level. -20 dBV, 100 mV RMS Minimum Input Level: -36 dBV. 16 mV RMS Maximum Input Level: 0 dBV. 1.0V RMS System Hum & Noise: (Measured @ Nominal Levels. 20 Hz to 20 kHz unweighted) 80 dB below rated power Equalization: (Low & High Active Type) +/-12 dB @ 80 Hz & 5 kHz Tape Output: Load Impedance: 10K ohms or greater Designed Output: -20 dBV. 0.1V RMS EXPOSURE TO EXTREMELY HIGH NOISE LEVELS MAY CAUSE A PERMANENT HEARING LOSS. INDIVIDUALS VARY CONSIDERABLY IN SUSCEPTIBILITY TO NOISE INDUCED HEARING LOSS. BUT NEARLY EVERYONE WILL LOSE SOME HEARING IF EXPOSED TO SUFFICIENTLY INTENSE NOISE FOR A SUFFICIENT TIME. THE U.S. GOVERNMENT S OCCUPATIONAL SAFETY AND HEALTH ADMINISTRATION (OSHA) HAS SPECIFIED THE FOLLOWING PERMISSIBLE NOISE LEVEL EXPOSURES OURATION PER DAY IN HOURS. SOUND LEVEL dBA. SLOW RESPONSE ACCORDING EAR PLUG6$¡ EXPOSU^WxCESi PERSOf#aa*0SED TO E UNIT 15.Ш OPERATION. ^..EXPOSURE IN OF THE ABC^Í^RI “ THE EAR CiW$№$*$R OVER THE$»P$.MUST BE W LIMITS АЗШ^ТН ABOVE TÔfctèURE AGAIN! "INT CAPA*fe£<*rf¡WQDUCING H^IPSOUND P“ THIS A*#*U?»ER HAS BEEN DESIGNED:-' HAND! fcfflSiCASIONAL PEAK POWER RECOMW©*®sD SINCE TH&tt&DLD C CONTROL fcTJiHE INPUT ««HAL IS' 1. Read n9 msjrae&ns before product 'S* .. 2. All satety ana operating instructions should be retained for future reference. 3. Obey all cautions in the operating instructions and on the back of the unit. 4. All operating instructions should be followed. 5. This product should not be use...

Otros modelos de este manual:
Instrumentos Musicales - Solo (554.47 kb)

Comentarios



Tu reseña
Tu nombre:
Introduzca dos números de la imagen:
capcha





Categoría