Votos - 2, Puntuación media: 4
(
)
)
|
Resumen del manual
15 mV RMS Minimum Input Level: -54 dBV. 2 mV RMS Maximum Input Level: +6 dBV. 2.0V RMS High Z Microphone Input: Input Impedance: High Z. 33K ohms Nominal Input Level: -16 dBV. 150 mV RMS Minimum Input Level: -34 dBV. 20 mV RMS Maximum Input Level: +26 dBV. 20V RMS High Z Auxiliary Input: Input Impedance: Very High Z. 2.2M ohms Nominal Input Level. -20 dBV, 100 mV RMS Minimum Input Level: -36 dBV. 16 mV RMS Maximum Input Level: 0 dBV. 1.0V RMS System Hum & Noise: (Measured @ Nominal Levels. 20 Hz to 20 kHz unweighted) 80 dB below rated power Equalization: (Low & High Active Type) +/-12 dB @ 80 Hz & 5 kHz Tape Output: Load Impedance: 10K ohms or greater Designed Output: -20 dBV. 0.1V RMS EXPOSURE TO EXTREMELY HIGH NOISE LEVELS MAY CAUSE A PERMANENT HEARING LOSS. INDIVIDUALS VARY CONSIDERABLY IN SUSCEPTIBILITY TO NOISE INDUCED HEARING LOSS. BUT NEARLY EVERYONE WILL LOSE SOME HEARING IF EXPOSED TO SUFFICIENTLY INTENSE NOISE FOR A SUFFICIENT TIME. THE U.S. GOVERNMENT S OCCUPATIONAL SAFETY AND HEALTH ADMINISTRATION (OSHA) HAS SPECIFIED THE FOLLOWING PERMISSIBLE NOISE LEVEL EXPOSURES OURATION PER DAY IN HOURS. SOUND LEVEL dBA. SLOW RESPONSE ACCORDING EAR PLUG6$¡ EXPOSU^WxCESi PERSOf#aa*0SED TO E UNIT 15.Ш OPERATION. ^..EXPOSURE IN OF THE ABC^Í^RI “ THE EAR CiW$№$*$R OVER THE$»P$.MUST BE W LIMITS АЗШ^ТН ABOVE TÔfctèURE AGAIN! "INT CAPA*fe£<*rf¡WQDUCING H^IPSOUND P“ THIS A*#*U?»ER HAS BEEN DESIGNED:-' HAND! fcfflSiCASIONAL PEAK POWER RECOMW©*®sD SINCE TH&tt&DLD C CONTROL fcTJiHE INPUT ««HAL IS' 1. Read n9 msjrae&ns before product 'S* .. 2. All satety ana operating instructions should be retained for future reference. 3. Obey all cautions in the operating instructions and on the back of the unit. 4. All operating instructions should be followed. 5. This product should not be used near water, i.e. a bathtub, sink, swimming pool, wet basement, etc. 6. This product should be located so that its position does not interfere with its proper ventilation. It should not be placed flat against a wall or placed in a built-in enclosure that will impede the flow of cooling air 7. This product should not be placed near a source of heat such as a stove, heater, radiator or another heat producing amplifier TED TO fttfWIDE ADEQlfi ~ ' HEA886QM HAS BEf IATED fcWftSPEAKER % power supply e power supply < 9. Never break oft the ground pm on the power supply more information on grounding write for our free booklet "Shock Hazard and Grounding." 10. Power supply cords should always be handled carefully Never walk or place equipment on power supply cords Periodically check cords for cuts or signs of stress, especially at the plug and the point where the cord exits the unit 11. The power supply cord should be unplugged when the unit is to be unused for long periods of time. 12 Metal parts can be cleaned with a damp rag. The vinyl covering used on some units can be cleaned with a damp rag. or an ammonia based household cleaner if necessary j&sdonot f...
Otros modelos de este manual:Instrumentos Musicales - Solo (554.47 kb)