Completely open the fuel shut-off valve (Figure 17). Make sure the valve is fully open. A partially closed fuel shut-off valve (Figure 18) combined with the use of the choke can result in a fouled spark plug and engine failure. 4. Place the Forward/Reverse handle in the NEUTRAL position. Crank the engine until fuel is pumped into the carburetor and fuel lines and the engine starts. Turn the engine off. See following NOTE. NOTE: Due to the oil added to the engine in preparation for storage, engin

• Study and understand controls. TO START ENGINE • Place shift lever in “N” Neutral position. • Press brake pedal. • Turn key switch to “START position and release. TO OPERATE VEHICLE • Turn wheels to desired direction and ensure path is clear. • Engine must be at idle before moving shift lever. • While vehicle is stopped, and engine is at idle, place Forward/Reverse switch in desired position: F Forward N Neutral R Reverse (Buzzer will sound) • Park brake will release and vehicle will start mov

See Battery – Gasoline Vehicles on page 39. Front wheel alignment and camber Check and adjust if necessary. See Section 7 – Steering and Front Suspension in the appropriate maintenance and service manual. Electrical wiring and connections Check for tightness and damage. Brake system Check brake shoes; replace if necessary. Lubricate brake slides. See Periodic Lubrication Schedules on page 32. Check brake cables for damage; replace if necessary. Annual service by trained technician only (or every

(98 cm) Weight (without batteries) 544 lb. (246 kg) Weight (dry, without battery) 669 lb. (303 kg) Forward speed 17 mph (27 km) Vehicle Specifications continued on next page... Page 46 2006 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual Vehicle Specifications SPECIFICATIONS Electric HUV4210-E Electric HUV4210EXP Gasoline HUV4210-G Gasoline HUV4210GXP Standard seating capacity 2 LIQUID CAPACITIES Transaxle 22 oz. (0.67 L) Engine crankcase (without filter) 32 oz. (0.95 L) Engine c

6.2. Loosen, but do not remove, the carburetor drain screw and drain fuel remaining in bowl into a small, clean container, then pour the fuel from the container into vehicle fuel tank. Tighten the carburetor drain screw. 6.3. Fill fuel tank to about 1 inch (2.5 cm) from top of fuel tank and, following manufacturer’s directions, add a commercially available fuel stabilizer (such as Sta-Bil®). 6.4. Disconnect fuel vent line from fuel tank vent nipple. 6.5. Plug the fuel tank vent nipple so that it

• If wires are removed or replaced make sure wiring and wire harness are properly routed and secured. Failure to properly route and secure wiring could result in vehicle malfunction, property damage, personal injury, or death. • Lift only one end of the vehicle at a time. Use a suitable lifting device (chain hoist or hydraulic floorjack) with 1000 lb. (454 kg) minimum lifting capacity. Do not use lifting device to hold vehicle in raisedposition. Use approved jack stands of proper weight capacity

NOTE: If the vehicle is constantly subjected to heavy use or severe operating conditions, the preventive maintenance procedures should be performed more often than recommended in the Periodic Service and Lubrication Schedule. Both the Periodic Service Schedule and the Periodic Lubrication Schedule must be followed to keep vehicle in optimum operating condition. PERIODIC SERVICE SCHEDULE REGULAR INTERVAL SERVICE Daily service by owneror trained technician Engine Check engine oil level; add if nec

• Unload cargo bed before raising vehicle with a lift, hoist, or jack. • Avoid stopping on a hill when loaded. If you must stop on a hill, avoid sudden starts, or rollingbackwards and stopping suddenly. Failure to heed this warning may cause vehicle to overturn, possibly resulting in severe personal injury. WARNING CONTINUED ON NEXT PAGE... Page 22 2007 HUV 4421 Gasoline and Diesel Vehicle Owner’s Manual Vehicle Load Capacities y WARNING • Reduce speed and avoid sudden stops when backing up. Fai

• Frame ground – Do not allow tools or other metal objects to contact frame when disconnecting batteries or other electrical wiring. Never allow a positive wire to touch the vehicle frame, engine, or other metal component. PERIODIC SERVICE SCHEDULES See General Warnings on page 10. y WARNING • Service, repairs, and adjustments must be made per instructions in the maintenance and service manual. NOTE: If the vehicle is constantly subjected to heavy use or severe operating conditions, the preventi

No other warranties, express or implied, are contained herein. Please complete and return the warranty registration card included in this manual. Husqvarna is not liable for errors in this manual or for incidental or consequential damages that result from the use of the material in this manual. This manual contains proprietary information that is protected by copyright. All rights are reserved. No part of this manual may be photocopied, reproduced, or translated to another language without the w