Votos - 4, Puntuación media: 4
(
)
)
|
Resumen del manual
Safety Information BEFORE YOU BEGIN Read these instructions completely and carefully. • IMPORTANT — Save these instructions for local inspector’s use. Observe all governing codes and ordinances. • Note to Installer — Be sure to leave these instructions with the Consumer. • Note to Consumer — Keep these instructions with your Owner’s Manual for future reference. • Skill Level — Installation of this dishwasher requires basic mechanical and electrical skills. Proper installation is the responsibility of the installer. Product failure due to improper installation is not covered under the GE Appliance Warranty. • Completion Time — 1 to 3 Hours. New installations require more time than replacement installations. • IMPORTANT — The dishwasher MUST be installed to allow for future removal from the enclosure if service is required. If you received a damaged dishwasher, you should immediately contact your dealer or builder. READ CAREFULLY. KEEP THESE INSTRUCTIONS. FOR YOUR SAFETY Read and observe all CAUTION and WARNINGS shown throughout these instructions. While performing installations described in this booklet, gloves, safety glasses or goggles should be worn. For Monogram local service in your area, 1.800.444.1845. For Monogram service in Canada 1.888.880.3030 For Monogram Parts and Accessories, call 1.800.626.2002. CONTENTS Installation Preparation Parts Supplied..............................................................................3 Materials You Will Need ............................................................3 Tools You Will Need ....................................................................3 Models Available ........................................................................4 Advance Planning ......................................................................4 Prepare Dishwasher Enclosure ................................................4 Drain Requirements ....................................................................5 Prepare Electrical Wiring ..........................................................6 Prepare Hot Water Line..............................................................7 Installation Instructions Step 1, Check Door Balance......................................................7 Step 2, Remove Wood Base, Install Leveling Legs ..............8 Step 3, Remove ToeKick ............................................................8 Step 4, Install Power Cord ........................................................8 Step 5, Install 90° Elbow ............................................................8 Step 6, Position Water Line and House Wiring......................9 Step 7, Install Drain Hose, Guide Through Cabinet ..............9 Step 8, Slide Dishwasher Partially Into Cabinet ....................9 Step 9, Install Trim Pieces..........................................................9 Step 10, Position Dishwasher Under Countertop ................10 Step 11, Level Dishwasher ......................................................11 Step 12, Secure Dishwasher To Cabinet ..............................12 Step 13, Connect Water Supply ..............................................13 Step 14, Connect Drain Line ....................................................13 Step 15, Connect Power Supply..............................................14 Step 16, Pre-Test Check List....................................................14 Step 17, Dishwasher Wet Test ................................................15 Step 18, Replace Toekick ........................................................15 Step 19, Literature ....................................................................15 Custom Panel Dimensions Custom Panel for Models ZBD6890, ZBD0700......................15 2 Installation Preparation PARTS SUPPLIED: • Two #8-18 x 5/8" Phillips special head screws, to secure dishwasher to underside of countertop or sides of cabinets. (Taped to top side of dishwasher.) • Side and top trim pieces (on some models) • Template with mounting hardware (not shown) for Model ZBD6890 Only • Drain Hose and Hose Clamp #8 Phillips Special Head Screws 5/8" Long Drain Hose Hose Clamp Trim Pieces (on some models) MATERIALS YOU WILL NEED: • Ferrule, compression nut and 90° Elbow (3/8" NPT external thread on one end, opposite end sized to fit water supply) • Thread seal tape • UL Listed wire nuts (3) Materials For New Installations Only: • Air gap for drain hose, if required • Waste tee for house plumbing, if applicable • Electrical cable or power cord, if applicable • Screw type hose clamps • Strain relief for electrical connection • Hand shut-off valve • Water line 3/8" min. copper • Coupler for extending drain line, if applicable Wire Nuts (3) Hot Water line Screw Type Hose Clamps Coupler Hand Shut-Off Valve Thread Seal Tape Air Gap Strain Relief 90° Elbow, Ferrule and Compression Nut Electrical Cable (or Power Cord, if applicable) Waste Tee TOOLS YOU WILL NEED: • Phillips head screwdriver • 5/16" and 1/...
Otros modelos de este manual:Lavavajillas - MONOGRAM ZBD0710 (678.39 kb)
Lavavajillas - MONOGRAM ZBD6890 (678.39 kb)
Lavavajillas - MONOGRAM ZBD6880 (678.39 kb)
Lavavajillas - MONOGRAM ZBD6800 (678.39 kb)