Votos - 3, Puntuación media: 3.7
(
)
)
|
Resumen del manual
If the toilet seat riser is not properly assembled and installed, personal injury and damage to the toilet seat riser could result. WARNING: If components are damaged or missing, contact your dealer immediately. DO NOT use substitute parts. Use only Lumex replacement parts. Non-Lumex replacement parts could cause personal injury and damage to the toilet seat riser. WARNING: This product has a weight limit of 300 lb. WARNING: GF Health Products, Inc. assumes no responsibility for any damage or injury caused by improper assembly, installation or use of this product. INSTALLATION 1. Remove toilet seat riser, hardware, and armrests from carton and protective packaging. 2. Install the armrests with the following steps: a. Identify the right and left armrests by the R (Right) and L (Left) stamped into armrest ends. b. Note that each toilet seat riser armrest socket is also stamped with an R or L, as shown at right. Insert each armrest marked with R or L into the socket with the corresponding letter. c. Push each armrest into its sockets until it clicks into place. d. Ensure locking buttons protrude fully from holes. Pull on armrests slightly to test proper installation. If loose, repeat step c. 3. At the toilet, lift the cover plates at top rear toilet bowl rim, exposing the bolts holding the seat and lid to the toilet bowl. 4. Use a Phillips or blade screwdriver, whichever is appropriate, to unscrew toilet seat bolts by turning counterclockwise. 5. Remove the toilet seat and lid from the toilet bowl and set them aside. 6. Place the toilet seat riser over the toilet bowl rim so that the toilet seat riser mounting holes align with the toilet rim holes. 7. Place the toilet seat and lid on top of the toilet seat riser so that the seat/ lid holes align with the riser and rim holes. 8. Install a washer on one of the long bolts included in the box and insert it through the top of the toilet seat lid, toilet seat riser, and toilet bowl rim. 9. Place a washer and wing nut on the end of the long bolt that protrudes through the bottom of the toilet bowl. hardware 6482R-2 assembled 6482ER-2 assembled “R” on armrest socket locking button toilet seat riserarmrest right armrest shown installed (shown upside down) mounting holes 6482ER-2, one arm attached (shown upside down) boltwasherswingnut 6486R-2-INS-LAB-RevA11 10. Use a Phillips or blade screwdriver, whichever is appropriate, to turn the bolt clockwise until toilet seat riser and toilet seat lid are snug. Do not overtighten. 11. The toilet seat riser should now be securely installed on the toilet bowl. To ensure that you have a proper fit, intentionally shake the toilet seat riser to ensure proper placement and fit. The toilet seat riser should not move; if it does, re-install. OPERATION WARNING: Always ensure the toilet seat riser is securely installed before use. MAINTENANCE WARNING: Check the toilet seat riser weekly for signs of damage or cracking. If damage or cracking is found, DO NOT use the toilet seat ...
Otros modelos de este manual:Baño - LUMEX 6482ER-2 (111.76 kb)