Votos - 2, Puntuación media: 4 ( )

Fabricar: Electrolux Tamaño del archivo: 877.51 kb Nombre del archivo: Idioma del manual:

Use the hole to attach a chain descending from the wall (arrow/Fig.4c). Making sure the chain is shorter than the gas and electric connections. Note: Appliances on wheels must be secured by fasten it to the building. 2. ACCESS TO INTERIOR Note: Only authorized technicians may access the interior. Fig. 3 Plinth assembly To assemble the plinth you will need: • Right and left side plinth (1 / Fig.3). • Plinth for the front and, for free-standing appliances, for the rear also (2 / Fig.3). O Push the side plinth (1 / Fig.3) onto the legs from front to rear using the fastener. The larger gap (b / Fig.3) on the fastener must be at the bottom. O Affix the fasteners (3 / Fig.3) to the plinth (2 / Fig.3). O The larger gap (b / Fig.3) on the fastener must be at the bottom. O Attach the plinth with the fasteners (3 / Fig.3) onto the feet. b a b Seite 6 62.9677.01 UL INSTALLATION INSTRUCTIONS El Electrolux 2.1 FRONT PANELS (A) and (B) 3. DOWNPIPE Fig.6 Front panel O Unscrew screws (1 or 3). Also, in the case of a built-in oven, unscrew screws (2 and/or 4) on the inside of the oven. O Pull the panel away forwards and downwards. 2.2 CONTROL PANEL (C) Fig. 7 Control panel Fig. 8 Downpipe Work surfaces with a downpipe (Fig.8a) have the downpipe opening on the right-hand side of the appliance. A flexible silicon hose when installed in the standard manner ends underneath and to the right, 0.8“ (20 mm) behind the front of the appliance (Fig.8b). O Alternatively, the hose can be relocated to the rear and be routed through other pre-cut openings (Fig.8c). a b c O Remove the knob. O Loosen the screws underneath (1 / Fig.7a) and remove the base plate. O Loosen the screws (2 / Fig.7b) and 3 / Fig.7c) O Remove the panel. 2.3 OVEN, STORAGE SPACE, HOT CABINET O Remove panels A, B and C. O Undo screws (5). O Pull out element. 62.9677.01 UL Seite 7 0] Electrolux INSTALLATION INSTRUCTIONS 4. GAS CONNECTION The installation of the gas connection, as well as the laying of the customer's gas line, is only to be carried out by an authorised specialist subject to the relevant national and local regulations. NOTE • The gas appliance may only be installed in an adequately ventilated location. • Appliances are set up for natural gas. The type of gas, gas pressure and gas category are entered on the specification plate. Prior to connection, check that the appliance is set up for the type of gas available on site. To do this, compare the details on the specification plate with the existing gas data. • If this is not the case, the appliance must be converted or adapted by the service personnel responsible to suit local conditions. The following points should be noted: - Has the appliance been tested for the new gas data? - Conversion in accordance with the Service Manual. - A new specification plate or a durable marking with the new gas data must be affixed to the appliance. 4.1 CONNECTION Gas-only appliances as well as combination electric and gas appliances require a gas connection. The gas connection is located under the appliance on the right hand side. For all types the gas connection is NPT 3/4“. The installation of a dirt trap in the gas supply line by the owner is recommended. After connection, all lines carrying gas must be tested for leaks at operating pressure by painti...

Descargar ahora

Introduzca dos números de la imagen: