Votos - 4, Puntuación media: 4 ( )

Fabricar: Maytag Tamaño del archivo: 2.91 mb Nombre del archivo: Idioma del manual:

La instalacion del triturador ha terminado. Llene el fregadero con agua usando el tapon. Retire el tapon, encienda el triturador de desperdicios y compruebe si hay perdidas abajo del fregadero. Lea TODAS las INSTRUCCIONES DE SEGURIDAD en la siguiente columna antes de operar el triturador. CONNECT DISPOSER TO MOUNTING ASSEMBLY Clear any objects from inside the disposer grind chamber before mounting the disposer to the sink. 1. Position disposer with three mounting tabs (A) aligned in position to slide over mounting tracks (B) (see Figure 10-1). 2. Lift disposer, insert top end (mounting gasket) into mounting assembly, and turn lower mounting ring to right (with wrenchette or screwdriver) until mounting tabs lock over ridges (C) on mounting ring tracks (see Figure 10-2). (MAKE SURE ALL THREE MOUNTING TABS ARE LOCKED OVER RIDGES.) Disposer will now hang by itself. (NOTE: ATTACH DISCHARGE TUBE TO WASTE DRAIN LINE Two-Bolt Discharge Tube or One-Bolt Discharge Tube . Two-Bolt Discharge Tube Installation (Preferred Two-Bolt Installation) If replacing existing disposer, remove and discard existing discharge tube and gasket. (Unit will not seal properly with old discharge tube.) 1. A) over discharge tube (B) (see Figure 11-1). 2. Insert rubber gasket (C bolts (D). 3. Rotate disposer so that discharge tube is aligned with drain trap. (To prevent leaks, do not pull or bend discharge tube to drain trap.) If discharge tube is too long, cut off as much of tube as necessary with hacksaw (make sure cut is straight and clean.) If discharge tube is too short, you can purchase an extension from a hardware store. (Disposer must remain in vertical position to prevent vibration.) 4. Place P-trap nut, then beveled washer (not supplied) on bottom of discharge tube and tighten on drain trap. (If you have a double sink, use separate drain traps for both sides.) 5. Although the supplied discharge tube is preferred, a straight discharge may be used (see Figure 11-2). Slide metal A) over straight discharge tube (B, not supplied), install rubber gasket (C) into discharge outlet, and secure D). One-Bolt Discharge Tube Installation (Preferred One-Bolt Installation) 1. A) over discharge tube (B) (see Figure 11-3). 2. Rubber gasket (C to disposer with bolt (D). 3. Rotate disposer so that discharge tube is aligned with drain trap. (To prevent leaks, do not pull or bend discharge tube to drain trap.) If discharge tube is too long, cut off as much of tube as necessary with hacksaw (make sure cut is straight and clean.) If discharge tube is too short, you can purchase an extension from a hardware store. (Disposer must remain in vertical position to prevent vibration.) 4. Place P-trap nut, then beveled washer (not supplied) on bottom of discharge tube and tighten on drain trap. (If you have a double sink, use separate drain traps for both sides.) 5. straight discharge tube to disposer with one bolt (reference Figure 11-2). CONNECT DISHWASHER DRAIN (IF APPLICABLE) Connect the dishwashe...

Descargar ahora

Introduzca dos números de la imagen: