Votos - 1, Puntuación media: 4
(
)
)
|
Resumen del manual
wide models. ZXD30B—This kit provides for the installation of a custom front panel on 30. wide models. Tools Needed NOTE TO CONSUMER: Keep this Owner’s Manual and Installation Instructions for future use. NOTE: This appliance must be properly grounded. NOTE: Insure that the power cord does not contact the hot surfaces on the bottom of ovens, cooktops, or any other appliance. Product Dimensions 27. 231.4. 9. 1. A 101.2. 261.4. Including handle Dimension A 27 . Drawer 30 . Drawer 26 3.4 . 30 . 2 x4 or 2 x 2 lumber for runners and brace Saw Wood screws and adhesive or other hardware Level for installing runners or shelf to support Drill and 1/16. bit warmer drawer. Phillips screwdriver Runners must be level, rigidly mounted and capable of supporting 150 pounds. 10 Safety Instructions Operating Instructions Care and Cleaning Installation Instructions Troubleshooting Consumer Support Read these instructions completely and carefully. Advance Planning The warming drawer may be installed directly into a wall or wall oven cabinetry. The warming drawer may be installed below a countertop, a single or double oven and side by side using 2 drawers. When installing warming drawer with a cooktop allow a 2. minimum from bottom of a cooktop burner box to top of cutout. Electrical power cord is located on the right side of the warming drawer. Locate the outlet within reach of the 56. long power cord in adjacent cabinet, within 42. of the right side or 16. from the left side of the cutout. A recessed receptacle can be installed on the right side of the cutout, 7. maximum from the back of the cabinet. Grounding the Appliance IMPORTANT—(Please read carefully) FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED. Do not use an extension cord or adapter plug with this appliance. Follow National Electrical codes and ordinances. This warming drawer must be supplied with 120V, 60Hz, and connected to an individual, properly grounded branch circuit, and protected by a 15 or 20 amp circuit breaker or time delay fuse. Recessed receptacle 7. max. from rear on right side Drill 11.2. hole for power cord for left or right side outlet Rating plate A properly grounded 3-prong receptacle should be located within reach of the drawer’s 56. long power cord. Locate the receptacle in an adjacent cabinet. —within 42. of the right side or, —within 16. of the left side or —A recessed receptacle may be located on the right side of the cutout, 7. maximum from the back of the cabinet. In this location, the excess power cord should be coiled and taped to the right side of the unit. location IMPORTANT—(Please read carefully) The power cord of this appliance is equipped with a 3-prong (grounding) plug that mates with a standard 3-prong grounding wall receptacle to minimize the possibility of electric shock. The customer should have the wall receptacle and circuit checked by a qualified electrician to make sure the receptacle is properly grounded and has the correct polarity. Where a standard 2-prong wall receptacle is encountered, it is the personal responsibility and obligation of the customer to have it replaced with a properly grounded 3-prong wall receptacle. Do not, under any circumstances, cut or remove the third (ground) prong from the power cord. DO NOT USE AN EXTENSION CORD. 11 Read these instructions completely and carefully. Installation Below Wall Ovens Installation below a single oven 231.2. WARNING! IN CANADA THE WALL OVEN IS ONLY APPROVED FOR INSTALLATION WITH A BOTTOM CUTOUT AT A MINIMUM OF 32.5" FROM THE FLOOR. Installation below a double oven 231.2. 2x2 or 2x4 anti-tip block against rear wall 9” from floor to bottom of block Min. 2x2 or 2x4 anti-tip block against rear wall 9” from floor to bottom of block 1. Min. above toekick or adjust to oven installation height A 2. Min. Allow 5/8” overlap on all sides 231.4. 9. 91.4. B Oven cutout 2. Min 1. Min. above toekick Dimension A Dimension B 27 . Drawer 25 1.2. 26 3.4. 30 . Drawer 28 1.2. 30 . Min. Allow 5/8. overlap on all sides 231.4. 9. 91.4. Oven cutout B Safety Instructions Operating Instructions Care and Cleaning Installation Instructions Troubleshooting Consumer Support NOTE: Additional clearance between cutouts may be required. Check to be sure that oven supports above the warming drawer location do not obstruct the required interior 231.2. depth and 91.4. height. 101.2. NOTE: Additional clearance between cutouts may be required. Check to be sure that oven supports above the warming drawer location do not obstruct the required interior 231.2. depth and 91.4. height. WARNING! IN CANADA THIS DRAWER IS NOT APPROVED FOR INSTALLATION UNDER A DOUBLE OVEN. 101.2. When installed, the front face of the warming drawer will be nearly flush with cabinetry doors or drawer fronts. Drawer overlaps will conceal cut edges on all sides of the opening. The rough opening for the drawer must be: —Depth: 231.2. minimum from inside back to front of cabinet frame. —Width: 251.2. for 27....
Otros modelos de este manual:Otros aparatos de cocina - PTD915 (299.64 kb)