Votos - , Puntuación media:
(
)
)
Fabricar: Bolens
Tamaño del archivo: 2.09 mb
Nombre del archivo:
Idioma del manual:
El documento se está cargando, por favor, espere
 |
El documento se está cargando, por favor, espere
Resumen del manual
Leaks can be located by passing a piece of cardboard or wood over the suspected leak and look for discoloration. 8. Should it become necessary to loosen or remove any hydraulic fitting or line, be sure to relieve all pressure by shutting off the engine and moving the control handle back and forth several times. 9. Don't remove the cap from the hydraulic tank or reservoir while your log splitter is running. Hot oil under pressure could cause injury. 10. Never store outside without a waterproof cover. Rain will cause rust on the inside of the cylinder. & CAUTION THIS UNIT SHOULD NOT BE TOWED ON ANY STREET, HIGHWAY OR PUBLIC ROAD. ANY LICENSING NE EDED TO COMPLY WITH THE EXISTING FECERAL, LOCAL OR STATE VEHICLE REQUIREMENTS IS THE SOLE RESPONSIBILITY OF THE PURCHASER. 4 FIGURE 1. TAPERED BEARING (TAPER TO INSIDE) HUB CAP ASSEMBLY INSTRUCTIONS CONTENTS OF HARDWARE PACK (See Figure 1): (A) (2) Spacers (B) (2) Tapered Roller Bearings (C) (2) Hex Castle Nuts 3/4-16 Thread (D) (2) Cotter Pins (E) (2) Hub Caps (F) (1) Shoulder Bolt (G) (1) Flat Washer (H) (1) Automotive Grease (I) (1) Tow Hitch and Stand (Not Shown - See Figure 7) (J) (1) Ferrule (K) (1) Hairpin Cotter TOOLS REQUIRED: (1) Raw Hide or Plastic Hammer (1) 1-1/8" Wrench or Adjustable Wrench (1) 3/4" Wrench (1) Pipe Wrench OTHER MATERIALS NEEDED: (A) One gallon of regular grade gasoline (for engine) (B) (C) (E) (F) 1-1/2 pints of SAE 30or 10W-30oil (for engine) Approximately 2-1/2 gallons of Dexron II automatic transmission fluid. (May be obtained at your local service station or auto parts store.) Funnel Pipe Sealant 1. Pack the tapered roller bearings with automotive grease. NOTE Do not put any grease in the hub caps. FIGURE 2. (CUT-A-WAY VIEW) AXLE TAPERED ROL L F F, BEARING fH) — - , 2. Place one spacer (A) on axle, then one wheel and tapered roller bearing (B). See figures 2 and 3. FIGURE 3. 5 I FIGURE 4. 3. Thread hex castle nut (C) on axle. Tighten castle nut until snug, then back off approximately 1/3 turn or until one of the slots on the castle nut lines up with hole in axle. Secure castle nut to axle with cotter pin (D). See figure 4. NOTE Make certain wheel bearings were packed with grease before assembly. hammer- FIGURE 5. ENGAGEMENT HAND .E ENGAGEMENT ROD HAIR PIN COTTER
Otras herramientas - 244-642-000 (2.09 mb)
Otras herramientas - 24642L (2.09 mb)
Otras herramientas - 24645L (2.09 mb)