Votos - 3, Puntuación media: 3.3 ( )

Fabricar: Sanyo Tamaño del archivo: 96.95 kb Nombre del archivo: Idioma del manual:

(See figure-4) 1. Remove the connector “K16B” of the circuit board. 2. Loosen the A, B, C wire holder and remove the lens motor lead. 3. Remove screws D (4 screws) which fastens the lens and remove the lens. Fig-4 3 INSTALL THE LENS. (See figure-4,5) 1. Remove protective caps (front and back ) on the lens. 2. Mount the lens at the lens mounting bracket with screws (4 screws) included with the lens. Use the driver included with the lens to fasten the screws . (After using, save it for latter use.) (See figure-5) 3. Connect the lens motor lead to the connector “K16B” of the circuit board. (See figure-4) 4. Fasten the lens motor lead at the A, B, C points with wire holder. (See figure-4) LENS MOUNTING BRACKET 4 INSTALL THE LIGHT-BLOCK SHEET. (See figure-6) Install the light-block sheet around the lens as shown in the illustration. (Use the sheet included with the lens.) LIGHT-BLOCK SHEET When in install the both upper and lower lens covers, put the light-block sheet through the lens and install the sheet so that it should be placed in the guide slot of the lens cover. (See figure-8) If the installation of the light-block sheet is incorrect, there will be the space between lens and the lens cover, so that it will be the cause of leakage of light or the dust entering at the main cabinet. 1.Insert the upper part lens cover and fix them with screws A (4 screws). 2.Insert the lower part lens cover and fix them with screws B (2 screws). 5 MOUNT THE LENS COVER. (See figure-7) UPPER LENS COVER ^Removed lens cover in figure-2 is not used, keep the cover for possible reuse when current lens is used. Insert into the slot. Set the light-block sheet, so that the large rounder side is set over the lens. LIGHT-BLOCK SHEET Fig-8...

Descargar ahora

Introduzca dos números de la imagen: