Fabricar: HP
Tamaño del archivo: 315.84 kb
Nombre del archivo:
![en en](/images/flag/s/en.gif)
![]() |
Otros manuales para este modelo:
Resumen del manual
ID
Message and Corrective Action
13905
Reboot
but attempts to exclude it from the SAN were unsuccessful! Rebooting it will allow
normal matrix operation to continue. Alternatively, if the server cannot be rebooted,
but can be confirmed to have no access to the SAN, run ‘mx server markdown
Action. Matrix Server cannot fence a server that is no longer communicating with
the matrix. Either reboot the server or run the mx server markdown command
to restore normal operations. Before using mx server markdown, be sure that
the server is physically down. If the command is run on a server that is not down,
filesystem corruption can occur. See “Server cannot be fenced” in the Matrix Server
administration guide for more information about the mx server markdown command.
13906
Server
Action. None. Alert 13905 is resolved.
13907
Reboot
may be dirty, but attempts to exclude it from the SAN were unsuccessful. Rebooting
it will allow normal matrix operation to continue. Alternatively, if the server cannot
be rebooted, but can be confirmed to have no access to the SAN, run ‘mx server
markdown
Action. Matrix Server cannot fence a server that is no longer communicating with
the matrix. Either reboot the server or run the mx server markdown command
to restore normal operations. Before using mx server markdown, be sure that
the server is physically down. If the command is run on a server that is not down,
filesystem corruption can occur. See “Server cannot be fenced” in the Matrix Server
administration guide for more information about the mx server markdown
command.
13908
Server
Action. None. Alert 13907 is resolved.
13909
Membership partitions are corrupt or inaccessible, preventing SAN access.
Action. Determine the state of each membership partition. Open the Configure
Matrix window and go to the Storage Settings tab, which shows the state of each
partition. If a single membership partition is corrupt, use the Repair feature to
resilver the partition while the matrix is online. If two partitions are corrupt, shut
down the matrix on all nodes and then resilver the partitions. If all of the
membership partitions are corrupt, you will need to restore the partitions from a
backup. If the state for a partition is NOT FOUND or INACCESSIBLE, there may
be a problem with the disk containing the partition or with another SAN component.
When the problem is repaired, the status should return to OK.
PolyServe Matrix Server event notification guide
31
...