Votos - 2, Puntuación media: 3.5
(
)
)
|
Resumen del manual
Remove the doorbell’s battery compartment cover. 2. Insert 4 AA batteries. 3. To change the doorbell tone, use a flat blade screwdriver to remove TONE, and insert it into the other two pins. 4. Slide CH 123 to the same channel as the indoor intercom. 5. Slide VOL 1 2 3 to the desired volume and replace the cover. 6. Plug the indoor intercom into a standard AC outlet. 7. Mount the doorbell using the supplied bracket, anchors, and screws as shown. Doorbell Intercom BELL — Press to sound the indoor PRESS TO TALK — intercom. Hold down to talk to the other person. 12 3OUTDOOR A B C CHANNEL — CHANNEL — Set to the same channel as the doorbell intercom. Indoor Intercom TALK — Hold down to talk over the intercom. TALK TO DOOR — Hold downtotalk to the other person. CALL—Press tosound an alert tone to the other station. VOLUME — Adjusts volume and powers it on and off. © 2002 RadioShack Corporation. All Rights Reserved. RadioShack and RadioShack.com are trademarks used by RadioShack Corporation. Set multiple intercoms to the same channel to communicate with them. 8. If desired, mount the indoor intercom using the supplied anchors and screws as shown. OPERATION 1. Rotate VOLUME on the indoor intercom counterclockwise until it clicks. Then adjust VOLUME to the desired listening level. 2. To turn off the indoor intercom, rotate VOLUME clockwise until it clicks. 3. Press BELL on the doorbell to sound the indoor intercom. Hold down TALK TO DOOR on the indoor intercom to reply. When you release TALK TO DOOR,the caller can reply by holding down PRESS TO TALK on the doorbell intercom. USING MULTIPLE INTERCOMS USING MULTIPLE INTERCOMS CALLING ANOTHER STATION Be sure the intercom stations you plan to use are turned on and adjusted to the desired volume. Press CALL to sound a tone alerting the person at the other station that you are about to speak. The CALL indicator lights. CAUTIONS AND WARNINGS • Dispose of old batteries promptly and properly. Do not burn or bury them. • Use only fresh batteries of the required size and recommended type. Do not mix old and new batteries, different types of batteries, or rechargeable batteries of different capacities. • If you do not plan to use the doorbell for two weeks or longer, remove the batteries. Batteries can leak chemicals that can destroy electronic parts. • This product is equipped with a three-wire grounding-type plug. This plug only fits into a grounding-type power outlet. If youare unable to insert theplug intoyourAC outlet, contact your electrician to replace your outlet. • Be sure you install the stations at least 10 feet away from each other. Placing the stations too close together produces feedback ( a squeal or howl from the speakers). The stations can transmit up to 300 feet, including between buildings, as long as they are connected to the same power line transformer. RadioShack Corporation Fort Worth, Texas 76102 NOTES • There are two levels of low battery condition. The door bell unit still works correctly at level 1. It does not work at level 2. When it reaches the first level, the indoor unit sounds an alert tone for about five seconds and POWER blinks periodically. If there is no key press before the replacement of new batteries, the indoor unit sounds a beep tone every minute. It can be stopped by pressing any key on the indoor unit. If BELL is pressed at level 1, or the indoor unit is resetatlevel 1 or2, POWER returns to normal in about two minutes, and another low battery signal is sent to the indoor intercom. The indoor intercom sounds an alert tone again for about five seconds, then sounds a reminder beep every minute. • The doorbell and indoor intercoms have three selectable operation channels to prevent interference from similar products nearby. Select the same channel for both the doorbell intercom and the indoor intercom. • If the doorbell occasionally sounds without anyone pressing BELL, change the channel settings. • If there is no voice communication between the doorbell and the indoor intercom within about 10 seconds, the intercom may be disabled and should be initialized by pressing BELL again. WARNING: To reduce the risk of fire or shock hazard, do not expose this product to rain or moisture. .. CAUTION.. The lightning symbol is intendedtoalert youto the presence of uninsulated dangerous voltage within this product’s enclosure that might be of sufficient magnitude to constitute a risk of electric shock. Do not open the product’s case. The exclamation symbol is intended to inform you that important operating and maintenance instruc- tions are included in the literature accompanying this product. ! RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK, DO NOT REMOVE COVER OR BACK. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL. CARE Keep the system dry; if it gets wet, wipe it dry immediately. Use and store the system only in normal temperature environments. Handle the system carefully; do not drop i...