Votos - 2, Puntuación media: 5
(
)
)
|
Resumen del manual
Do not open the product’s case. ! This symbol is intended to inform you that important operating and maintenance instructions are included in the literature accompanying this product. The graphical symbols with supplemental markings are located on the bottom of the product. Features 3 12-1630.fm Page 4 Tuesday, May 9, 2000 1:31 PM ¶ Preparation CONNECTING TO AC POWER Plug the clock radio’s power cord into a standard AC outlet. As soon as you connect AC power, the display turns on and BATTERY SENTINEL on the front of the clock radio lights. Caution: The clock radio’s AC power cord is equipped with a polarized plug to prevent electric shock. One blade on the cord’s plug is wider than the other and the plug only fits an outlet one way. If you cannot easily insert the plug, turn it over and try again. Do not force it. INSTALLING A BACKUP BATTERY To keep the clock running for up to 8 hours and the alarm sounding for up to 10 minutes during an AC power failure, install a 9-volt battery (not supplied) in the battery compartment. For the longest life, we recommend a RadioShack alkaline battery. Caution: Use only a fresh battery of the required size and recommended type. Notes: • BATTERY SENTINEL on the front of the clock radio lights if there is either no battery installed or the installed battery requires replacement. • To prevent unnecessary drain on the battery, plug in the AC power cord then install the battery. 4 Preparation 12-1630.fm Page 5 Tuesday, May 9, 2000 1:31 PM 1. While holding back the tab on the battery compartment cover, pull up the cover to remove it. 2. Snap the battery onto the connector in the compartment and place the battery in the compartment. BATTERY SENTINEL turns off. 3. Replace the cover. When BATTERY SENTINEL lights, check or replace the backup battery. When you connect a new battery, BATTERY SENTINEL turns off. Warning: Always dispose of an old battery promptly and properly. Do not burn or bury it. Caution: Always remove an old or weak battery. Batteries can leak chemicals that can destroy electronic parts. Notes: • The display does not light when the clock radio is operating only on battery power. • A prolonged power failure can drain the battery. If the display flashes after an AC power failure, the battery is too low to run the clock. Replace the battery and reset the clock. Preparation 5 12-1630.fm Page 6 Tuesday, May 9, 2000 1:31 PM ¶ A Quick Look at Your Clock Radio (illus - show front and right side of the clock radio) 6 A Quick Look at Your Clock Radio 12-1630.fm Page 7 Tuesday, May 9, 2000 1:31 PM ¶ Operation SETTING THE TIME 1. To set the hour, hold down TIME then repeatedly press (or hold down) HOUR until the desired hour appears. PM lights to indicate a PM hour. 2. To set the minute, hold down TIME then repeatedly press (or hold down) MINUTE until the desired minute appears. SETTING THE ALARM TIME 1. Slide ALARM/AUTO/OFF/ON to OFF. 2. Hold down ALARM and repeatedly press (or hold down) HOUR until the display shows the desired alarm hour setting. PM lights to indicate a PM hour. 3. Hold down ALARM and repeatedly press (or hold down) MINUTE until the display shows the desired alarm minute setting. 4. To confirm the alarm time, press ALARM. 5. Rotate VOLUME to set the desired alarm sound level (buzzer alarm or radio). USING THE ALARM To have the buzzer sound or the radio turn on at the preset alarm time, slide ALARM/AUTO/ON/OFF to ALARM for a buzzer alarm or to AUTO to have the radio play as the alarm. At the pre- Operation 7 12-1630.fm Page 8 Tuesday, May 9, 2000 1:31 PM set time, the alarm sounds or the radio turns on for up to 1 hour, 59 minutes then automatically turns off. To turn off the alarm, slide ALARM/AUTO/ON/OFF to OFF. To resume the alarm, slide ALARM/AUTO/OFF/ON back to ALARM (for buzzer) or AUTO (for radio). USING SNOOZE To temporarily silence the alarm for about 9 minutes, press SNOOZE. You can repeat this cycle as many times as you like. To turn off the alarm so it does not sound again, slide ALARM/ AUTO/OFF/ON to OFF. USING THE SLEEP TIMER You can set the radio to play for up to 1 hour and 59 minutes then automatically turn off. 1. Slide ALARM/AUTO/OFF/ON to OFF, AUTO, or ALARM. 2. Press SLEEP, 0:59 appears on the display. To select the desired sleep time, hold down SLEEP, then press (or hold down) MINUTE or HOUR. Release SLEEP when you reach the desired play time. 3. To turn off the radio before it automatically turns off, press SNOOZE. Note: If you press SLEEP again, the sleep time is reset to 0:59. PLAYING THE RADIO 1. Rotate VOLUME toward Min. to turn down the volume. 8 Operation 12-1630.fm Page 9 Tuesday, May 9, 2000 1:31 PM 2. To turn on the radio, slide ALARM/AUTO/OFF/ON to ON. 3. Slide BAND to FM or AM then rotate VOLUME to a comfortable listening level. 4. Rotate TUNING. A pointer indicates the station’s frequency on the dial. Note: The AM antenna is built-in. Rotate the clock radio for the best AM reception. The AC power cord also serves as the FM ...