Votos - 3, Puntuación media: 4 ( )

Fabricar: Philips Tamaño del archivo: 3.12 mb Nombre del archivo: Idioma del manual:

By doing this, you help to preserve the environment. Guarantee & service If you need service or information or if you have a problem, please visit the Philips website at or contact the Philips Consumer Care Centre in your country (you find its phone number in the worldwide guarantee leaflet). If there is no Consumer Care Centre in your country go to your local Philips dealer Troubleshooting This chapter summarises the most common problems you could encounter with the appliance. If you are unable to solve the problem with the information below, contact the Consumer Care Centre in your country 10 ENGLISH Problem Possible cause Solution The iron is plugged in, but the soleplate stays cold. There is a connection problem. Check the mains cord, the plug and the wall socket. The temperature dial is set to MIN. Set the temperature dial to the required position The iron does not produce any steam. There is not enough water in the water tank. Fill the water tank (see chapter 'Preparing for use', section 'Filling the water tank). The steam control is set to position 0. Set the steam control to a position between 1 and 4 (see chapter 'Using the appliance', section 'Steam ironing'). The iron is not hot enough and/or the drip-stop function has been activated (specific types only). Set an ironing temperature that is suitable for steam ironing ( 2 to MAX). Put the iron on its heel and wait until the temperature light goes out before you start ironing. Water droplets drip onto the fabric during ironing. You have put an additive in the water tank. Rinse the water tank and do not put any additive in the water tank. You have not closed the cap of the filling opening properly Press the cap until you hear a click. Flakes and impurities come out of the soleplate during ironing. Hard water forms flakes inside the soleplate. Use the Calc-Clean function one or more times (see chapter 'Cleaning and maintenance', section 'Calc-Clean function'). The red auto-off light flashes. The automatic shut-off function has switched off the iron (see chapter 'Features'). Move the iron slightly to deactivate the automatic shut-off function. The red auto-off light goes out. Water drips from the soleplate after the iron has cooled down or has been stored (specific types only). You have put the iron in horizontal position while there was still water in the water tank. Always set the steam control to position 0 and empty the water tank after use. Store the iron on its heel. The iron does not produce a steam boost. You used the steam boost function too often within a short period. Continue ironing in horizontal position and wait a while before you use the steam boost function again. The iron is not hot enough. Set an ironing temperature at which the steam boost function can be used (temperature settings 2 to MAX). Put the iron on its heel and wait until the temperature light goes out before you use the steam boost function. DANSK 11 Tillykke med di...

Descargar ahora

Introduzca dos números de la imagen: