When replacing the battery pack, please follow the same procedure. V__J WARNING TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. Clean the battery charging contacts in handset and base unit regularly with a dry cloth so that sufficient contact is made. (PRECAUTIONS ) • Before initial use, charge the battery pack in the battery compartment of the handset for approximately 12 to 16 hours wit

RC004288 TAC-5000 (Part #. RC004287)for FT-5005 or TAC-5000 BK (Part #. RC004304) for FT-5005 BK Part #. RC001861 Part #. RC004289 Part #. RC004284 Part #. RC000936 WMA-3000 (Part #. RC003561) for FT-5005 or WMA-3000BK (Part #. RC003562) for FT-5005 BK TROUBLESHOOTING GUIDE Should any problem occur with the set, make the following simple tests to determine whether or not servicing is required. If the problem persists after you have made these tests, call 1-800-631-3811 for Customer Serv

TV, radio, appliances. -9- WALL-MOUNTING THE BASE You can mount your cordless telephone's base unit on a wall using two provided screws. © Cut out the template (see page 11) and use it as a guide for placement on the mount screws. (315/i6 inch apart). (D Thread the screws into the wall, letting the heads extend about 1/s inch. Route the phone cord and AC adaptor cord through the guides on the back of the base unit. 3^-(100mm): WALL AC Adaptor Cord i c -— Telephone Cable — -É- (5mm)

A beep tone comes out from the base unit and the handset. © Press the Talk button on the handset within ten seconds to communicate between the handset and the base unit. The Intercom LED and the Talk LED light up. Speak normally. ® To end the communication, press the Talk button on the handset. -Notes - If the Power ON/OFF switch is in the OFF position by mistake during the communication, this mode stops and some noise may generate out of the base unit. This is not an electrical problem and

• Plug the AC adaptor into the wall outlet. • Plug the AC adaptor cord into the power jack on the base unit. • Take the cover off the handset battery compartment; plug the battery connector into the receptacle inside the battery compartment and replace the cover. The connector only goes in one way. • Place the handset into the base unit’s charging cradle. The IN USE/CHARGE LED should light. If not, see TROUBLESHOOTING, page 32. • The battery charging period has now started. From now until the 12