Votos - 4, Puntuación media: 4.3
(
)
)
|
Resumen del manual
If the CD player has only one audio output jack, connect it to either the right or left audio input jack of the main unit. Connect the audio cable's red plug to the red jack and white cable to the white jack. M . CD player COAXIAL OUT AUDIO OUT or HW-C700-C770S-C770BS-ELS_0504.in23 23 2010-05-04 11:41:40 24 Connections CONNECTING 7.1 CHANNEL DEVICES You can connect the AV receiver to a DVD player, SUPER AUDIO CD player or other device with 7.1 channel output. FRONT SURROUND SURROUND BACK SUB WOOFER CENTER 5.1 CH 7.1 CH C SW SW C 7.1 Channel device HW-C700-C770S-C770BS-ELS_0504.in24 24 2010-05-04 11:41:45 25 ENG . CONNECTIONS CONNECTING AN iPod You can listen to audio from an iPod through the main unit. For iPod operation with your receiver, see this page and pages 50 ~ 51. Connect the iPod dock connector to the iPod jack on your reciever. Place the iPod in the Dock. If you want to play a movie stored in your iPod player, you should set the player's TV Out option to On before inserting it into the dock. See page 51. Press the iPod button on the remote control. You can also use the INPUT SELECT button on the main unit. The mode switches as follows : FM BD/DVD SAT TV VCR CD AUX 7.1 MULTI CH IPOD AUDIO IPOD VIDEO Disconnecting an iPod Follow the steps below to prevent damage to an iPod and data when disconnecting from your AV receiver. Press the INPUT SELECT button on the main unit to switch to a mode other than IPOD AUDIO or IPOD VIDEO. OR Turn off the AV Receiver. Disconnect the iPod player from the iPod dock, or remove the iPod dock connector from the AV receiver. You must have the VIDEO (Monitor or VCR) output connected to your TV to view iPod video. See page 22. Adjust the volume to a moderate level before you connect your iPod and AV Receiver. When the unit is powered on and you connect an iPod, the unit will charge your iPod's battery. Make sure to connect the dock connector so that the label “SAMSUNG” faces upward. “Made for iPod” means that an electronic accessory has been designed to connect specifi cally to an iPod and has been certifi ed by the developer to meet Apple performance standards. “Works with iPhone” means that an electronic accessory has been designed to connect specifi cally to an iPhone and has been certifi ed by the developer to meet Apple performance standards. 1. 2. • 3. • 1. 1. 2. M . .... . iPOD HW-C700-C770S-C770BS-ELS_0504.in25 25 2010-05-04 11:41:49 Connections CONNECTING AN iPod (Continued) iPod models that are compatible with HW-C700/C700B/C770S/C779S /C770BS M . "Made for iPod" means that the dock has been designed to connect specifically for the iPod and has been certified by the developer to meet Apple performance standards. . Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. iPod is a trademark of Apple Inc., registered in the U.S. and other countries. iPhone is a trademark of Apple Inc. 26 HW-C700-C770S-C770BS-ELS_0504.in26 26 2010-05-04 11:41:54 27 ENG . CONNECTIONS CONNECTING THE FM ANTENNA Connect the FM antenna supplied to the FM ANTENNA terminal as a temporary measure. Slowly move the antenna wire around until you fi nd a location where reception is good, then fasten it to a wall or other rigid surface. Do not place the antenna cable close to the power cord. Keep it as far away as possible. If you experience poor FM reception, use an external antenna. CONNECTING AUX COMPONENTS You can connect external devices you use for a short time (camcorder, game console, mobile equipment,etc.) to the front of this unit for convenience. 1. 2. M . . AUDIO OUT VIDEO OUT Camcorder FM antenna (supplied) HW-C700-C770S-C770BS-ELS_0504.in27 27 2010-05-04 11:41:54 Basic functions of your AV Receiver BEFORE USING THE AV RECEIVER Turning On/Off Connect the power plug to the outlet. Press the POWER button on the main unit for 2 seconds. • This unit will be turned on or set to Standby mode. • You can also turn the unit on/off by pressing the POWER button on the remote control. Remote control functions You can operate your AMP (this AV receiver)/ TV and BD(Samsung only)/DVD player with this remote control. See pages 54 ~ 55 for more details. To select a function Method 1 Press the INPUT SELECT button. • Each time you press this button, FM BD/DVD SAT TV VCR CD AUX 7.1 MULTI CH IPOD AUDIO IPOD VIDEO will be selected in turn. Method 2 Press the TUNING/CH, BD/DVD, SAT, TV, CD, MULTI CH, VCR/AUX or iPod button. • You can directly select the desired function. AUDIO SETUP Selecting a source device and connection jack Select the external devices you have connected to the receiver. 1. Press the SETUP/MENU button. • Each time the button is pressed, the mode switches between SETUP ENTER and SETUP OFF. .. 2. Press the ENTER button to select SETUP ENTER. 3. Press the ^Ў buttons to select AUDIO SETUP, and then press the ENTER or > button. 4. Press the ^Ў buttons to select a desired jack. • Devices switch as follows; BD/D...
Otros modelos de este manual:El receptor y el amplificador - HW-C700 (9.9 mb)
El receptor y el amplificador - HW-C770S (9.9 mb)