Votos - 4, Puntuación media: 5
(
)
)
|
Resumen del manual
6) • Insert end of shift rod into hole of shift lever indicator. • Insert hairpin clip through hole of shift rod to secure with bend of clip on right side. • Grasp handle assembly. Hold in “up” position. Ensure handle lock remains in gearcase notch. Slide handle assembly into position. Fig. 4 HANDLE ASSEMBLY "UP" POSITION LOOSEN HANDLE LOCK LEVER TO MOVE TIGHTEN HANDLE LOCK LEVER TO HOLD • Rotate handle assembly down. Insert rear carriage bolt first, with bolt head on L.H. side of tiller and loosely assemble locknut (See Fig. 5). • Insert pivot bolt in front part of plate and tighten. • Cut down remaining corners of carton and lay panels flat. • Lower the handle assembly. Tighten nut on carriage bolt so handle moves with some resistance. This will allow for easier adjustment. • Place flat washer on threaded end of handle lock lever. • Insert handle lock lever through handle base and gearcase. Screw in handle lock lever just enough to hold lever in place. • Insert second handle lock (with teeth in ward) in the slot of the handle base (just inside of washer). • With handle assembly in lowest position, securely tight en handle lock lever by rotating clockwise. Leav ing handle assembly in lowest position will make it easier to remove tiller from carton. SHIFT ROD HAIRPIN CLIP SHIFT LEVER INDICATOR Fig. 6 REMOVE TILLER FROM CRATE • Ensure shift lever indicator is in “N” position (See Fig. 6). • Tilt tiller forward by lifting handle. Separate cardboard cover from leveling shield. • Rotate tiller handle to the right and pull tiller out of carton. CHECK TIRE PRESSURE The tires on your unit were overinflated at the factory for shipping purposes. Correct and equal tire pressure is important for best tilling performance. • Reduce tire pressure to 20 PSI (1.4 kg/cm2). HANDLE HEIGHT • Handle height may be adjusted to better suit operator. (See “TO ADJUST HANDLE HEIGHT” in the Service and Adjustments section of this manual.) 5 6 KNOW YOUR TILLER READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TILLER. Compare the illustrations with your tiller to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference. These symbols may appear on your Tiller or in literature supplied with the product. Learn and understand their meaning. CAUTION TILLING FORWARD NEUTRAL REVERSE OR WARNING ENGINE FAST SLOW ON ENGINE OFF CHOKE FUEL OIL TILLING TINE CONTROL DEPTH STAKE SHIFT LEVER LEVELING SHIELD ENGINE ON/OFF SWITCH RECOIL STARTER HANDLE SHIFT LEVER IN DI CA TOR THROTTLE CONTROL OUTER SIDE SHIELD Fig. 7 MEETS ANSI SAFETY REQUIREMENTS Our tillers conform to the safety standards of the American National Standards Institute. CHOKE CONTROL - Used when starting a cold engine. DEPTH STAKE - Controls depth at which tiller will dig. DRAG STAKE - Controls forward speed in forward rotating till position. ENGINE ON/OFF SWITCH - The engine switch enables and disables the ignition system. FUEL VALVE - The fuel valve opens and closes the passage between the fuel tank and the carburetor. TINE CONTROL - Used to engage tines. LEVELING SHIELD - Levels tilled soil. OUTER SIDE SHIEL...
Otros modelos de este manual:Herramientas de jardín - 21547000 (2.18 mb)
Herramientas de jardín - 21547000 (2.18 mb)
Herramientas de jardín - 21547000 (2.18 mb)
Herramientas de jardín - 21547000 (2.18 mb)