Votos - 2, Puntuación media: 4
(
)
)
|
Resumen del manual
1.2 Recommended Tools Flat Blade Screwdriver 2-1/4" DIA. (57mm) Hole Saw Teflon Tape Electric Drill ROUGHING-IN DIMENSIONS ALL CONNECTIONS 1/2" NPT 74mm D. (2-15/16" 1660.130 Multifunction Round Body Spray 1660.140 Multifunction Square Body Spray 1 INSTALL SUPPLY PIPING CAUTION Turn off hot and cold water supplies before beginning. ■ Provide a "Installation Hole" 2-1/8" - 2-3/8" DIA., (54-60mm) and 3-1/4", (83mm) deep. Note: The "Installation Hole" must be clear to allow body spray clearance. ■ Install the ELBOW (1) on a support within the wall at the *dimension shown. Secure with two M5 SCREWS (2) (not provided). 2 INSTALL PLASTER GUARD ■ Make sure the O-RING (3) is installed on the PLASTER GUARD (1). ■ Install the PLASTER GUARD (1) into ELBOW (2). Note: The finished wall must be between the Min. & Max. lines on the PLASTER GUARD (1). ■ Complete all tiling and wall work. When walls are finished remove PLASTER GUARD (1). M968617 Rev.1.2 3 INSTALL BODY SPRAY Remove the PLASTER GUARD (1) if not already removed. Make sure the O-RING (2) and FLANGE GASKET (6) are installed on the BODY SPRAY (3). Thread BODY SPRAY (3) into the ELBOW (4). Tighten BODY SPRAY (3) using WRENCH (5) supplied until flush against finished wall and FLANGE GASKET (6) is compressed. Turn on water supply and test installed BODY SPRAY (3) for leaks and proper operation. 4 FINISHED WALL- INSTALL ESCUTCHEON Align ribs on back of ESCUTCHEON (1, 2), with slots in BODY SPRAY (3). Push ESCUTCHEON (1, 2) against BODY SPRAY (3) until ESCUTCHEON (1, 2) snaps into place. Turn on water supply and test installed BODY SPRAY (3) for leaks and proper operation. -ALIGNMENT RIBS ON BACK OF ESCUTCHEON 3 1 CARE: DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH. DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE. M968617 Rev. 1.2 5...
Otros modelos de este manual:Fontanería - 1660.13 (232.58 kb)