Votos - 4, Puntuación media: 4.3 ( )

Fabricar: Attwood Tamaño del archivo: 478.1 kb Nombre del archivo: Idioma del manual:

Figure 1 Cover Figure 1 Automatic Float Switch Front Tabson Switch#8 StainlessSteel Screws • • • • • • • Test Knob Rear Slots on Pump Bracket Attwood V-Series Pump 2. With switch in desired mounting position, mark the two mounting holes. 3. Set depth gauge on drill bit to prevent drilling through hull. Drill a 1/8" (3mm) diameter pilot hole at each mark. 4. Align switch over pilot holes. Feed wires under test knob or out rear of switch. Fasten switch using #8 stainless steel screws. Be sure screws penetrate wood only; do not screw into the boat hull.Figure 1 WIRING INSTRUCTIONS 5. Wire float switch and bilge pump as shown in any one of the three diagrams. Figure 2 Please note that in each case, float switch is in series (in-line) with pump and must be connected to the positive (+) battery terminal. The lead wires must terminate in a waterproof connection. Mount wires above the highest possible water mark. For extra protection, liberally coat butt joints and adjacent wire ends with liquid electrical tape. Failure to properly fuse and make the appropriate water-resistant connections will void the product warranty. CARE AND MAINTENANCE INSTRUCTIONS Periodically remove cover and clear away any debris that has accumulated around and under the float, around the float arms, and in the strainer slots. Periodically check the electrical connections to ensure that they are waterproof and mounted high and dry. Fuse (See Pump Maximum Length Specifications For Size) From (+) Terminal PumpAutomatic Float Switch 12 Volt Battery – + Black Wire FULLY AUTOMATIC OPERATION Brown Wire • • to Fuse Holder• Fuse (See Pump “ON/OFF/AUTO” OPERATION PumpAutomatic Float Switch Specifications for Size) Attwood Rocker Switch (Rear View) • • 12 Volt Battery – Black Wire Brown Wire • • 72" (183 cm) Maximum Length From (+) Terminal to Fuse Holder Fuse (See Pump “ON/AUTO” OPERATION • • PumpAutomatic Float Switch Specifications for Size) Two-Terminal, “On-Off” Type Switch Can Be Attwood Rocker, Push-Pull, or Toggle Type • • 12 Volt Battery – + Black Wire Brown Wire • • 72" (183 cm) Maximum Length From (+) Terminal to Fuse Holder ATTWOOD LIMITED WARRANTY ATTWOOD CORPORATION, 1016 North Monroe, Lowell, Michigan 49331, (“Attwood”), warrants to the original consumer purchaser that this Attwood Float Switch will be free from defects in materials and workmanship under normal use and service for a period of three (3) years from the date of original consumer purchase. This warranty does not extend to any batteries or fuses used with the float switch. This limited warranty is not applicable if the float switch has been damaged by accident, improper installation, unreasonable use, lack of proper maintenance, unauthorized repairs or modifications, or other causes not arising out of defects in materials or workmanship. Attwood's obligations under this warranty are limited to repair of the product at Attwood's plant or replacement of the product at Attwood's option and at Attwood's expense. Any ...

Descargar ahora

Introduzca dos números de la imagen: