Votos - 2, Puntuación media: 3.5
(
)
)
|
Resumen del manual
LP1 / LP2 OFF No synchronization with the ICOT. ARM (ESF Data Link) FF48 (hex) or 1111 1111 . GREEN Synchronized with good signal quality on NET Loop 1/Loop 2 0100 1000 (binary) sent ICOT and HRE(s) will arm and the HLIU will loop up toward the network. in the Facility Data Link (> 2 dB margin). YELLOW Synchronized with marginal signal quality on NET Loop 1/Loop 2 Disarm (in-band) 11100 (binary) All units are removed from the armed state and loopbacks will be released. (1 to 2 dB margin). Disarm (ESF Data Link) FF24 (hex) or 1111 1111 0010 0100 (binary) sent in All units are removed from the armed state and loopbacks will be released. RED Synchronized with poor signal quality on NET Loop 1/Loop 2 the Facility Data Link (0 dB margin). Activation ICOT1 D3D3 (hex) or If received while in an armed state, the ICOT will loop toward the network. CUSTOMER 1101 0011 1101 0011 (binary) LP1 / LP2 OFF No synchronization with the RT. Loop down w/out 9393 (hex) or Automatically releases without disarming any ICOT and HRE that may be in GREEN Synchronized with good signal quality on CUST Loop 1/Loop 2 disarming2 1001 0011 1001 0011 (binary) loopback toward the network. (> 2 dB margin). HRE Network Loop up1 C741 If an HRE is present and units armed, the HRE will loop up toward network.. YELLOW Synchronized with marginal signal quality on CUST Loop 1/Loop 2 (1100 0111 0100 0001) (1 to 2 dB margin). HLIU Loop up1 C742 If received while in an armed state, the HLIU will loop toward the network.. (1100 0111 0100 0010) RED Synchronized with poor signal quality on CUST Loop 1/Loop 2 1 Units must be armed with 11000b or FF48h before this code will work. (0 dB margin). 2 In order to behave like an NIU, the HLIU will not loop down from the network side with 9393h. LL / RL OFF No active arming or loopback is detected at the HRE. NOTE: All codes listed above must be sent for a minimum of 5 seconds in order for them to be detected and acted upon. YELLOW Indicates LB from HRE toward the network is active. GREEN Indicates LB from HRE toward the customer is active. Cable pairs must be nonloaded No single Bridged Tap > 2 kft Maximum loop resistance is 800 . Pulse attenuation (LOSS on HDSL Current System Status screen) < 30 dB Impulse noise < 50 dBrn as measured using a 50 kb filter Total Bridged Tap < 2.5 kft 196 KHz insertion loss < 35 dB Signal quality of 6 dB or higher, with no fluctuation and equal on both loops Wideband Noise < 31 dBrn as measured using a 50 kb filter Internal Clock Accuracy +25 ppm (exceeds Stratum 4) C A U T I O N C A U T I O NC A U T I O N ! SUBJECT TO ELECTROSTATIC DAMAGE OR DECREASE IN RELIABILITY. HANDLING PRECAUTIONS REQUIRED. For a complete Installation and Maintenance Practice (P/N 61179513L1-5): (877) 457-5007, Faxback Document 900. Please have your fax number ready. HOUSING DIAGRAMS ADTRAN 8-slot AT&T/Keptel/ABACON Above Ground Above Ground Below Ground SPC 6-slot SPC 8-slot AT&T/Keptel Above Ground Above Ground Above Ground POWERING OPTIONS The ICOT will power the entire Total Access 1000 System. When an HRE is used to extend the range of the POTS circuits, a second ICOT is used to provide auxiliary span power to the system through additional copper pairs. (See Figure 1). The Total Access 1000 system continues to receive span power through the HDSL loops. The second ICOT is only needed for its span powering capacity. No circuit information can be accessed from it. No DSX-1 connections are necessary. The loop will not train, and it will always show an alarm condition. Applications using only U-BR1Tes do not require an additional ICOT. WARRANTY ADTRAN will replace or repair this product within the warranty period if it does not meet its published specifications or fails while in service. Warranty information can be found at USA and Canadian customer Faxback: (877) 457-5007, Document 414. COMPLIANCE The 239 HRE complies with the requirements covered under UL 60950 and is intended to be installed in an enclosure with an Installation Code (IC) of “B” or “E.” Ensure chassis ground is properly connected. TURNUP GUIDE PRICING AND AVAILABILITY 800.827.0807 TECHNICAL SUPPORT 800.726.8663 RETURN FOR REPAIR 256.963.8722 61179513L1-22A ADTRAN 239 REPEATER HOUSINGS PART # Description HRE Capacity CLEI Code* Material 1150027L1 4-slot Air Stub 4 DDMOABA1MA Stainless Steel 1150027L2 4-slot Gel Stub 4 DDMOBBA1MA Stainless Steel 1152010L3 2-slot Gel Stub 2 DDMOBAE1RA Valox Plastic 1152010L4 2-slot Air Stub 2 DDMOAAE1RA Valox Plastic 1150057L1 4-slot Air Stub 4 DDMODA01RA Stainless Steel 1150057L2 4-slot Gel Stub 4 DDMOCA01RA Stainless Steel 1150058L1 8-slot Air Stub 6 DDMOEE01RA Stainless Steel 1150058L2 8-slot Gel Stub 6 DDMOFE01RA Stainless Steel 1190816L1 16-slot Air Stub 16 DDMOES01RA Stainless Steel 1190816L2 16-slot Gel Stub 16 DDMOFS01RA Stainless Steel HRE 239 DEPLOYMENT IN OTHER HOUSINGS Company Description HRE Capacity Material Above Ground Below Ground ...